Eaton Powerware PS10/0.4 replacement UPS battery set AGM
Replacement Eaton Powerware PS10/0.4 UPS battery pack, valve regulated sealed lead acid rechargeable absorbed glass mat batteries that will not spill offered at low prices direct from warehouse
Eaton was founded in America with a worldwide distribution network including Europe below you will find details of the battery you need for your Eaton Powerware PS10/0.4, the energy that is required for functioning is stored directly onboard it takes the mains supply and passes it through the batteries and is powered by 12v cells, and comes with 2 x 12-volt batteries and that is what this offer is for, they are of course recyclable as they are made from lead meaning that they are a environmentally friendly form of protection, and by fitting them in your machine you are prolonging the life of this equipment which is also a bonus rather than it ending on land fill, and why not there are years of life left in it yet.
- Eaton Powerware PS10/0.4 battery replacement
Fitting the batteries is quite an easy task to do yourself, you can refer to your manual for the procedure, once you have fitted them the system will want to fully charge the batteries, even though they will come out to you almost charged it will still want to complete the task, so there will be a period of time where you do not have the full protection that it can offer until it has completed this operation, we know it will not always be convenient as everything is a rush now days but if you can its best to run the system without any load to start
In this kind of device you would expect the batteries to last somewhere between two to five years, this will be very dependent on the use and the way the system is stored, good ventilation, if it's in a office do not use it as a book shelf, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span
These valve regulated sealed lead acid batteries will not leak so they can be mounted in tower or rack systems as they can be fitted on their side, they are not-hazardous so safe for busy data centres as well of course as the home office
Check the code on your UPS to ensure you are ordering the correct battery set, the size of the batteries are also specified below if you are unsure, many of the codes on UPS systems are similar
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
In this set there is 2 rechargeable batteries for the Eaton Powerware PS10/0.4 the physical dimensions of each battery is
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below
