PBQ1.2-6 6V 1.2Ah battery replacement, sealed lead-acid rechargeable AGM.
Replacement pbq1.2-6 rechargeable batteries, 6-volt 1.2Ah valve-regulated sealed lead-acid non-spillable safe battery pack, absorbed glass mat AGM cells, low competitive price.
Here you will find relevant information to help you consider purchasing a new compatible replacement battery for your pbq1.2-6; the 6v cells have an energy storage capacity of 1.2 amp-hours. They are also capable of deep cycling and are rechargeable. They are non-spillable and non-hazardous, so they're safe to handle and use indoors. They have an AGM and a VRLA type of cell; more information on the chemistry is available below.
- pbq1.2-6 battery replacement
After you have unpacked your new battery order from us, you will note that they have a good charge; regardless, you should still complete a full charge before first use. However, if it's a battery backup for something that's always connected to the mains, like a monitor or maybe an alarm system, then you do not need to charge it first, as the system will do that for you. it shouldn't take long, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long. Do not just install and use without this initial charge; unless as stated above, doing so can shorten expected lifespan. It's well worth doing.
Unless you are a very experienced user, you will probably not even notice that it can take a number of charge-and-use cycles in your equipment before a full-capacity charge is achieved; this is all part of the conditioning process and quite normal. Once you have used your portable equipment, then put the batteries back on charge; do not let them sit in a partially discharged state for any longer than absolutely necessary. you should never deliberately go out of your way to try fully discharge the batteries, we are often asked will this extend the life but no this will only reduce its life span and cost you money in the long run. It is important to keep a charge in the batteries for long life, so if there is any period of time where they are not being used, then charge beforehand and top this up every four weeks, but do not leave on a charger for more than 24-hours
These batteries require no general maintenance or topping up with fluid, as they have none. They are AGM and VRLA, of course, with deep-cycle properties required for this type of application; they are also non-hazardous, so safe to use in the home or in portable devices.
Check the information carefully to ensure you are ordering the correct battery, as many of them have very similar codes. If in doubt, you could check the dimensions of the batteries and note anything written on their sides. The size is also specified below for your confirmation. These 6-volt 1.2-amp-hour batteries are recyclable. The main component is lead, which can easily be recycled. More information on this can be found at the bottom of this page on our recycling link.
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = VRLA, AGM, sealed lead, Pb.
In this set, you will find 1 rechargeable battery to replace the PBQ1.2-6. The physical size of the individual batteries is as follows:
Length = 97mm or 3.81 inches
Width = 25mm 0.94-inches
Height = 52mm or 2.02 inches.
Ask about batteries
