Genie T113971GT Battery Replacement 12V 150Ah Flooded Deep Cycle.
High quality compatible replacement battery for Genie T113971GT, 12v 150ah flooded deep-cycle battery installed into electric scissor lifts.
This battery is built for Genie's electric-drive scissor lifts, where several units are normally wired together in series to form the higher-voltage pack that powers the drive motors and lift functions. Unlike a starting battery, its job isn't a quick burst of cranking amps, it's steady, sustained current over a full shift of driving, raising and lowering the platform. As the cells age, that shows up as shorter run time between charges and a machine that feels noticeably less punchy on drive and lift, which is usually the point a new battery set is required.
- Genie T113971GT battery replacement
Being a flooded battery, check the electrolyte level periodically and top up when it runs low. Plug the lift in and recharge fully at the end of every shift rather than parking it up half-charged, and if the machine is going to sit unused for a stretch, give the battery a top up charge every few weeks so it doesn't settle into a deep discharge state, which shortens the life of any lead acid cell fast.
Flooded lead-acid batteries are some of the most widely recycled products going, with the lead, plastic casing and electrolyte all recovered through standard battery recycling channels, so pass the old unit on to a scrap or battery recycler, or hand it back to your equipment supplier when the new one goes in.
AGM upgrades are also available through the easy upgrade section, providing sealed, spill-proof alternatives with less maintenance.
Depending on what machine you are installing this battery into, you may require multiple. Please add the correct amount to your cart or contact us where we may be able to provide a quote.
Capacity: 150ah + @20-Hr
Voltage: 12 volt
Chemistry: Wet or Flooded
Terminals: DT.
