Skip to Main Content

Alaris Medical 590 Keofeed Infusion Pump sealed battery pack 6v

£26.98 inc. VAT

Images for assistance only.
Share This Product
  • Model:BT630-25998
  • Battery Charge:Rechargeable
  • Battery Voltage:6.00 Volts
  • Battery Capacity:3.00 Ah
  • Battery Chemistry:AGM
  • Condition:New
  • Pack Contains:1
  • Shipping Weight:0.65 Kilos

Alaris Medical 590 Keofeed Infusion Pump sealed battery pack 6-volt
Replacement Alaris Medical 590 Keofeed Infusion Pump non-spillable small and compact sealed lead acid valve regulated 6-volt 3.2ah batteries, often used as backup or in portable devices AGM and VRLA, offered direct from warehouse at low cost

Here you on the page below will find we have compiled detailed information which should be enough to help you make a informed decision on the purchase of new replacement compatible battery for your Alaris Medical 590 Keofeed Infusion Pump, this type of battery is often seen in portable medical equipment as well as alarm systems as a emergency battery backup, they can store 3.2-amp hours of energy in the 6-volt cells and capable of deep cycling, these are of course as would be needed in such installations rechargeable, they are non spillable, safe and not-hazardous so safe to be handled, stored and used indoors, the cell structure is a composite of lead which is formed as AGM and VRLA, more information on these construction processes can be found below

  • Alaris Medical 590 Keofeed Infusion Pump battery replacement

This sealed lead battery that you obtain from us will be almost fully charged, but you should still charge them fully before first use, if it's going into a device that is always connected to the mains and has its own charging circuit like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, you do not need to leave it on for hours on end its almost fully charged, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, this first step is important so please do ignore it, unless of course as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span

Unless you are a very extended user you will probably not even notice that it can take a number of charge and use in your equipment before a full capacity charge is achieved, this is all part of the conditioning process and quite normal, when you have used your portable device then ensure you put the batteries back on charge, you do not want to allow them to sit in a partially discharged state, never go out of your way to deliberately discharge fully, this type of technology is not suitable for that kind of treatment, this will only reduce overall life span, If there are extended periods where the batteries are not being used then ensure they are fully charged beforehand then recharged every four weeks but you should not leave on the charger for more than 24-hours

This type of battery is valve regulated lead acid, VRLA for short, they still have acid but its trapped between a glass matting, this is why they are also called AGM or absorbed glass mat, you will never to need to top them up with fluid, if fact you cannot as they are sealed, they are not-hazardous and can safely be used indoors or in portable devices with no fear of leakage

We have provided the information here purely as a guide, it would be wise to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the best thing to do, this 6-volt 3.2ah battery is as you would expect recyclable, the main component is lead, more detailed information on recycling can be found at the foot of this page

Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead, AGM, VRLA

There are a total of 1 rechargeable lead acid batteries for the Alaris Medical 590 Keofeed Infusion Pump the overall size of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1

Alaris Medical 590 Keofeed Infusion Pump battery terminal layout guide


Frequently Asked Questions

Ask us a question

There are no Videos for this particular Product.
View our other help, technical, installation and information videos.

Installation Videos

We do have other Videos, subscribe to our Youtube Channel using the Button below.
Supplementary Files: None available

  • 98% of orders shipped same day for next day working day delivery in UK Mainland
  • FREE Delivery on orders of £45 and over in most of UK Mainland
  • We ship Worldwide, add to cart for delivery cost
  • You can return any order for any reason, in resaleable condition, within 14 days
  • Our full delivery and returns details can be viewed in the footer
Explore
0 item(s), £0.00

0 items