Elsar 23052 6-volt battery replacement sealed lead AGM VRLA
Replacement Elsar 23052 rechargeable compact 6-volt 3.2ah battery pack, valve regulated VRLA sealed AGM, safe non-spillable batteries which can be used in portable devices direct from warehouse at low price
Please find below the information on this page that we have compiled so you can make a educated decision on the purchase of a new replacement compatible battery for the Elsar 23052, with a capacity of 3.2-amp hours, you might find this size battery in medical equipment, portable and stationary as well as home and commercial alarm systems as emergency battery backup as well as many other uses, these 6-volt cells are also capable of deep cycling, which as you would expect and would require in this type of application, rechargeable, they're sealed and will not spill any liquids, so safe to handle and use indoors as well as more mobile use, they are AGM and VRLA offering a long life, more information on the chemistry of them will be found below
- Elsar 23052 battery replacement
After placing your order and receiving your new battery from us you may will note that they have a good charge in them, but you should still charge it fully before using for the first time, the only time you do not need to do this is if it's going into something with its own always connected power supply and charging circuit, for example a alarm system, as this will do the job of charging for you, the period of this initial charge before first use need only be until the charger states it is ready, probably not very long at all, do not miss out this very important first step, it will help set them up properly and possibly extend the possible overall life expectancy of them
If being used in a portable device it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, once you have used your portable equipment then make sure you put the batteries back on charge afterwards, do not let them sit in a partially discharged state for any longer than absolutely necessary, do not try to attempt to fully discharge the batteries, it will not rejuvenate them, in fact the opposite, it will reduce the lifespan and cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These 6-volt batteries are manufactured as AGM (absorbed glass mat) and VRLA (valve regulated lead acid) to the end user it means they are very versatile, they are sealed lead acid, the acid being suspended within a glass mat so will not leak and not-hazardous so can be used indoors or in portable devices, they also need no maintenance whatsoever, except of course charging
You should confirm the code on your old battery carefully, there are many that are very similar so you want to order the correct one, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions below so you can make certain you are ordering the correct one, this 6-volt 3.2ah product is recyclable it is constructed mainly of lead or Pb which is easily transformed into another useful item, please ensure they are disposed of properly at a recycling centre once they have completely fulfilled their purpose for you, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
There are 1 rechargeable batteries to replace the Elsar 23052 the overall size of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
