APC Back-UPS PRO BP650SC UPS battery pack replacement sealed lead
Replacement APC Back-UPS PRO BP650SC non-spillable sealed lead acid valve regulated UPS system batteries, AGM and VRLA that can be mounted on its side offered direct from warehouse at low cost
- APC BP650SC battery replacement
The batteries that we will send out to you will be almost fully charged, but the system will still need to finish off a full service charge, of course while this charge going on your UPS will not be able to offer the full runtime protection until its finished this, best advice would be to allow the system to run without load to start to allow the new battery energy level to reset
Batteries in this type of installation would typically have a expected life span of between 2 to five years, this will however very much depend on how they are used, good ventilation is always important, if it's in a office do not use it as a book shelf, the higher the load the harder its working which directly relates to battery life, if you can try to keep it below 40%
These batteries are absorbed glass mat, AGM and valve regulated sealed lead acid or VRLA for short, they require no maintenance and due to their chemistry can be mounted on the side in rack mounted or tower UPS systems without the fear of leakage, they are not-hazardous so can be used in data centres, hospitals and of course the home office.
Check the code on your UPS to ensure you are ordering the correct battery set, many codes are very similar, the size of the batteries are also specified below if you are unsure, the batteries are recyclable, more information about recycling can be found at the foot of this page.
Voltage = 12-volts
Capacity = 12ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM
Hot swap capable
In this set you will find a quantity of 1 quality lead acid batteries for the APC Back-UPS PRO BP650SC the overall size of each battery is
Length = 151mm
Width = 98mm
Height = 94mm
Battery layout - from chart below = 5
