Eaton Powerware 3115 650 UPS battery replacement pack sealed
Replacement Eaton Powerware 3115 650 battery pack, rechargeable valve regulated sealed lead acid UPS batteries, will not spill, safe not-hazardous at low prices direct from warehouse

Eaton was founded in America with a worldwide distribution network including Europe below you will find details of the battery you need for your Eaton Powerware 3115 650, it is powered by way of internal energy storage source these batteries are used to filter the mains supply and output a clean version without any spikes the cells are 6v cells, and comes with 2 x 6-volt batteries and that is what this offer is for, as you would expect they are rechargeable and as they are also recyclable to give them a long life and of course environmentally friendly, more information on recycling can be found on our recycle page

• Eaton Powerware 3115 650 battery replacement

We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, so there will be a period of time where you do not have the full protection that it can offer until it has completed this operation, we know it will not always be convenient as everything is a rush now days but if you can its best to run the system without any load to start

You would expect these kind of batteries to last between two to five years in this kind of device, this will however will vary greatly depending on the conditions or storage and overall use, using the system as part of the office furniture is not the best idea, it needs ventilation, the batteries will get very hot as they are working hard 24-hours a day, the more heat the shorter their life, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span

The cells are absorbed glass mat or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in tower or rack mountable configuration with fear of spillage in mission critical applications as well as the home office

Ensure that you order the right battery by checking the code on your UPS and comparing it to the information here, many are very similar, these hot swap capable batteries are recyclable, more information on this can be found at the bottom on this page on our recycling link.

Voltage = 6-volts
Capacity = 10Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable

This set contains a total of 2 ready to install batteries for the Eaton Powerware 3115 650 the dimensions of the individual battery pack are as follows
Length = 151mm
Width = 51mm
Height = 94mm
Battery layout - from chart below = 1

Hot swap capable, no maintenance required