APC Back-UPS-Pro BR650MI battery replacement tower sealed.
Replacement APC Back-UPS-Pro 650 BR650MI and BR650CI battery pack, rechargeable valve regulated safe sealed batteries for the tower uninterruptible power supply device at a low cost.
Computer backup device battery repair kit APC.

• APC Back UPS Pro BR650MI battery
• APC Back UPS RS BR650CI battery

Non spill No maintenance high quality backup batteries.
This pack is for one battery for the APC Back-UPS-Pro BR650MI. Fitting is quite simple but if in any doubt you should seek the advise of a professional. Here are a few tips if you are doing yourself, shutdown every thing attached to it first then the UPS and remove all the power leads including the mains power from the socket in the wall. Next step is to pull off the front cover, it should pull off with your fingers but sometimes they can be a bit stiff so a flat edged screwdriver might be in order to save your finger nails. Then you can see the battery do, this is probably held in place with two Phillips screws undo these and drop down the door, you can now see the batteries. Slide them out and swap the leads over onto the new batteries, put back in reverse order and you are finished.

We recommend powering up the UPS without any load to begin with, at least until the batteries are shown as fully charged, bit longer if you can this will go a long way to help improve the reset of the new batteries.
Uninterruptible power supply battery pack for APC Back-UPS-Pro BR650MI.
This is a recyclable product.
Chemistry of battery: sealed lead acid, AGM VRLA
Voltage: 12v
Capacity: 7Ah @20-Hr
This offer has a single battery required for the APC Back-UPS-Pro BR650MI system, the size of the battery pack is:
151mm long
65mm wide
94mm high