Invacare Linak BAJ100000011 battery mobility patient hoist 24v.
Replacement Invacare Linak BAJ100000011, BAJ1, BAJ2, J1BA-001 battery, pack of two 12v sealed lead acid batteries, combined as 24v in the mobility patient hoist. Non-spill at a low price.
It is straightforward to replace the batteries in the Invacare-Linak battery pack or box. Just put it on the workbench or table. You will see six screws that need to come out. Sometimes these may have a security head, but most people will have these in their toolbox nowadays, and if not, they are readily available in most do-it-yourself stores, even supermarkets. Once you have undone the six screws, you can lift off the cover and see the two batteries inside. Just put the two new batteries alongside and swap the cables over one at a time. There are only two cables on each and put it back together. The whole job will take you no more than five minutes.
- Invacare Linak battery
- BAJ100000011 battery
- Invacare BAJ1 battery
- Invacare BAJ2 battery
- Invacare J1BA-001 battery
rechargeable.
Sealed, non-spillable.
Not-hazardous.
No maintenance is needed.
Best to charge the new fitted batteries in the Linak pack fully before first use. the best way to look after this kind of battery is to charge after every use. If you only use a small piece of the energy stored, you will get thousands of charges. This will reduce significantly the further you discharge before charging, and never leave them in a discharged state. If not used for long periods, recharge every month.
There are two batteries in this pack. They are valve-regulated lead acid or VRLA. They also have the added benefit of being AGM or absorbed glass mat technology. They are safe to mount on their side as required on the Invacare-Linak battery pack, which is non-hazardous and recyclable. There is a link at the bottom of the page for further information about recycling.
The individual battery specifications are as follows
Battery Voltage: 12v (combine two to make 24v)
Capacity: 2.9ah @20-Hr
There are two batteries in this set for the Invacare Linak BAJ100000011. The size of each one is as follows:
length 78mm
width 55mm
height 97mm
F1 fast-on terminals.
Fitting service for Invacare Linak BAJ100000011, BAJ1, BAJ2, J1BA-001 hoist batteries:
The battery fitting is not difficult, but we understand that not everyone is comfortable doing such a job and might not even have the tools to handle it or have mobility issues.
We can do this for you. At the top of the page, under available options, you can select to include fitting with your batteries. If selected, we will email you the address to send your box to, along with packing and further instructions. Upon receipt of your parcel, we will then inspect & fit the new batteries for you and check that they output the correct voltage. If you want us to check your charger, too, at the same time, then we can at no extra fee. These are normally turned around the same working day, depending on what time it turns up.
