Pro-Rider Easyfold Deluxe S7-4 portable battery replacement.
Replacement battery for Easyfold Deluxe S7-4 from Pro-Rider, pair of safe 12v 10Ah AGM batteries for easy installation at low costs direct from the warehouse.
Pro-Rider is a manufacturer of electric vehicles that produced a range of mobility scooters that suits a range of different needs. The Easyfold S7-4 comes in different colours and is ideal for anyone that requires a small, transportable and cheap mode of transportation. As the name suggests it is easy to pack up and fold away into to make it compact and hassle-free, you can then put it in the boot of the car. The extra wheels at the rear allow it to be pulled along in a suitcase-style as well. On top of this, it has all the features you would expect from a brand leader such as a comfortable seat, anti-tip wheels and puncture-proof tyres.
The batteries required for the Easy-fold to work is a pair of twelve volt, ten ampere AGM batteries and that’s what we are offering here. They are non-hazardous, leakproof, valve regulated, and sealed lead acid which is safe for air transport however you should tell the airline at the point of booking that you are taking this. They are also environmentally friendly and can be recycled at the end of their useable life at your local recycling centre.
- Pro Rider Easyfold Deluxe battery
- Pro Rider S7-4 battery
Sealed AGM safe batteries, set of two as required.
How to charge and maintain Pro-Rider Easyfold Deluxe batteries?
Your new batteries will be able to take many charges over their useable lifetime but most of the damage occurs every time they discharge below 50-per cent and that number will be reduced just that little bit. To maximize the number of uses you get from a battery try not to discharge past this (that’s why higher ampere batteries are a good choice), charge after every use and if not being used for long periods charge every month to keep the cells fresh.
Installation of Pro-Rider Easyfold Deluxe battery set
Installing these batteries is fairly simple and can be done with just a screwdriver and some patience. Flip the battery box on its head (on a cloth of some sort to not scratch it) and undo the seven or so screws holding it together. Flip it back over and take off the lid. Inside you will see two batteries and four wires, two to each. Perhaps take a picture or memorise where the wires go so you know how to put them back in the correct place when you swap the batteries over.
Voltage: 12v x2 = 24v
Capacity 10Ah @20 hr
Chemistry: AGM.
The physical size of each battery in this pack of two for the Pro-Rider Easyfold Deluxe is as follows:
Length: 151mm or 5.94-inches
Wide: 65mm or 2.56-inches
Height: 110mm (115mm with terminals) or 4.33-inches