Eaton EB020SP and EB024SP battery replacement.
Twin-pack compatible battery replacement set for Eaton EB020SP and EB024SP UPS, compatible battery replacement pair to restore steady runtime and protection.

If your UPS is beeping more than it used to, failing a self-test, or showing a sharp drop in runtime, it’s usually the internal cells ageing out rather than the electronics. This page covers both models together because they share the same simple, two-battery layout.

These are compatible battery replacements and they’re a fully rechargeable battery type intended for standby use, meaning they’re happiest sitting on float charge and delivering power only when needed. Swapping both at the same time is the smart move on a two-block system. Mixing old and new often leads to uneven charging, quicker voltage sag, and a disappointing runtime the moment you actually need it.

• Eaton EB020 UPS battery replacement
• Eaton EB020 UPS battery replacement

The technology is sealed lead-acid (VRLA/AGM), so there’s no topping up, no maintenance routine, and no fuss. They’re spill-resistant and well suited to enclosed UPS bays where access is limited, while still delivering the high burst current a UPS demands during changeover.

For best life, keep the UPS in a cool, ventilated spot and avoid letting it sit fully discharged after an outage, recharge promptly. Try not to run the unit close to its maximum load all the time; heat build up is what shortens battery life fastest, and a calmer operating temperature usually means noticeably longer service from the pair.

Chemistry of battery: VRLA, AGM, Pb, and sealed lead.
The voltage of the battery: 12v.
The capacity of the battery: 8.8Ah @20-hr, amp-hour.

There are a total of two batteries in this set for the Eaton EB020SP and EB024SP The size of each is as follows:
Length = 151mm
Width = 65mm
Height = 94mm.