APC BK350, BK350-GR, BK-350-IT, BK350-RS, BK350-UK battery
Replacement APC Back-UPS CS 350 BK350, BK350-GR, BK-350-IT, BK350-RS, BK350-UK batteries, sealed easy to install batteries for this surge protected power supply
So the LED light is on and that horrible noise telling you the battery needs changing, its a easy job that you can do yourself in about 5 minutes. the procedure is simple, once yo have disconnected from your network and from mains power, release the battery door to expose the old battery and lay the new one along side, then just swap the two cables over and put back together, easy as that.
- APC BK350 battery
- APC BK350-GR battery
- APC BK-350-IT battery
- APC BK350-RS battery
- APC BK350-UK battery
We normally recommend that you run the UPS without load until the new battery is fully charged.
This replacement battery module contains a 12-volt sealed lead acid battery that requires no maintenance, and as it is sealed can be mounted on its side with fear of spillage
The BK350, BK350-GR, BK-350-IT, BK350-RS, BK350-UK is a APC Back-UPS 350, 210 watts, 350VA UPS system, fitting of the battery is quite easy, please refer to your manual
Compatible non spill maintenance free replacement battery
Uninterruptible power supply battery pack
These battery is valve regulated sealed lead acid or VRLA with AGM technology, they will not leak so cab be mounted on their side without fear of spillage and suitable for installation in UPS systems
Chemistry of battery: VRLA, AGM
Voltage of battery: 12-volt
Capacity of battery: 7Ah
Battery specification table
Length - 151mm
Width - 65mm
Height - 94mm
Total height including flat spade terminals - 100mm
We can also offer this battery as a 9ah version, completely the same size so it will slip straight in, think of it as a very easy upgrade for your UPS and it will offer a longer runtime
