Eaton Powerware Prestige 3000 UPS battery pack replacement
Replacement Eaton Powerware Prestige 3000 rechargeable battery pack, valve regulated sealed lead UPS system batteries with VRLA and AGM technology at low competitive price direct from warehouse
Below is the details of the batteries your will require to replace in your UPS system for the Eaton Powerware Prestige 3000, the system uses batteries to filter the input electricity and output a clean supply to protect your equipment behind it they are 12v cells, and comes with 10 x 12-volt batteries and that is what this offer is for, as you would expect they are rechargeable and as they are also recyclable to give them a long life and of course environmentally friendly, more information on recycling can be found on our recycle page
- Eaton Powerware Prestige 3000 battery replacement
We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise
You would expect these kind of batteries to last between two to five years in this kind of device, this will be very dependent on the use and the way the system is stored, ensure there is always good ventilations around the device, do not allow it to be used as a filing cabinet, if the batteries overheat it shortens the life span, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
The battery type is AGM or absorbed glass mat construction, they are also valve regulated, they can be used in tower or rack mounted UPS systems without any fear of leakage, they require no maintenance throughout the life span and are not-hazardous so safe for use indoors, the expected life span
Please note that the information on this page is only a guide, we have tried to assist you in getting the correct batteries for your UPS system, if you are not sure you can always check what you have before ordering, this will also give you the opportunity to see how easy it is going to be to change the batteries, if you look closely at the product code on your UPS then you shouldn't go wrong.
Voltage = 12-volts
Capacity = 4.5Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
There is 10 recyclable lead batteries for the Eaton Powerware Prestige 3000 the overall size of the batteries are
Length = 90mm
Width = 70mm
Height = 101mm
Battery layout - from chart below = 1
Hot swap capable, no maintenance required
