IMC Hartway Frontier PF1 PF1S scooter battery set disabled VAT relief
Replacement IMC Hartway Frontier PF1 PF1S scooter non-spillable sealed lead acid valve regulated 12-volt mobility batteries, AGM and VRLA disabled VAT relief available, offered direct from warehouse at low cost
Below you will find we have entered details of a set of new mobility batteries you will require for the IMC Hartway Frontier PF1 PF1S scooter, your electric vehicle utilises the batteries to store energy that is required for momentum they are 38amp hour batteries, it uses 2 x 12-volt batteries, they are compatible replacements for them, as you would expect they are rechargeable, they are made for mobility use and are deep cycle capable, unlike some batteries, and not-hazardous, they will not spill so safe to be handled and for use indoors, they are also recyclable and environmentally friendly, more information on recycling can be found on our recycle page
- IMC Hartway Frontier PF1 PF1S scooter battery replacement
The batteries that you obtain from us will be almost fully charged, but you still need to charge them fully before first use, just charge them until your charger LED lights indicate that they are ready, it will probably not take very long, this first step is important so do not ignore it, do not use without this initial charge, doing so can shorten expected life span
It's not something that most will notice but it will take a few charges and use in the equipment before a full capacity charge is reached, it's part of the normal conditioning process, as soon as you after each use put them back on charge, do not allow them to sit in a discharged state, do not try to fully discharge the batteries, it will reduce the lifespan and cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than four weeks
These 12-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or on the road or pavement without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not-hazardous so safe for use in travel including aeroplanes but you should check with your airline at time of booking
Check the code on your mobility equipment carefully to ensure you are ordering the correct battery set as many of them have very similar names of codes, if in doubt you could check the dimensions of the batteries and take note of anything that may be written on the side of them, the size of the batteries are also specified below so you can confirm, these batteries are made mainly of lead which is easy to transform so therefore environmentally friendly and recyclable, more information regarding recycling will be found at a link at the foot of this page
Voltage = 12-volts
Capacity = 38Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
This set contains a total of 2 ready to install batteries for the IMC Hartway Frontier PF1 PF1S scooter here is the dimensions of a single battery
Length = 195mm or 7.67-inches
Width = 165mm 6.49-inches
Height = 170mm or 6.69-inches
Battery layout - from chart below = 0

we are also able to supply this physical size battery with 50ah, this extended runtime version will slip in the same cavity as it's the same dimensions and offer you more miles per charge, link to this option will be just a little bit further below