RBP0124 RBP0016 battery CP1300EPFCLCD CP1500EPFCLCD CyberPower UPS.

Replacement RBP0124 and RBP0016 rechargeable battery pack for CyberPower CP1300EPFCLCD and CP1500EPFCLCD UPS devices at a low price.

Mid-to-high-end computer systems, servers, and networking hardware that uses conventional and Active Power Factor Correction (PFC) power supplies are safeguarded by the CyberPower CP900EPFCLCD-UK with Pure Sine Wave output. The GreenPower Technology used in the design of this UPS helps to increase operating effectiveness while lowering energy consumption, saving you a lot of money on energy costs compared to other UPS systems.

• CyberPower CP1300EPFCLCD battery
• CyberPower CP1300EPFCLCD-UK battery
• CyberPower CP1500EPFCLCD battery
• CyberPower CP1500EPFCLCD battery
• CyberPower RBP0124 battery
• CyberPower RBP0016 battery

To maintain safe voltage levels for the connected equipment, the UPS offers Automatic Voltage Regulation (AVR). The built-in data line protection shields phones, networks, and communication equipment from surges, spikes, and other power irregularities. With just one button press, users can configure advanced settings, such as alert of potential power problems and self-test, and access information about power/battery conditions.

Maintenance of RBP0124 and RBP0016 battery
This UPS's battery life should last between two and five years, according to CyberPower and the battery's manufacturers, but this is not a hard and fast rule since much depends on how they are used. The batteries will heat up during routine use, and the hotter they get, the shorter their lifespan, so adequate ventilation is needed. Keep the load at less than 40% to get a long battery life.

RBP0124 and RBP0016 Installation:
It only takes five minutes and a screwdriver to install the new battery in your UPS, and the process is surprisingly simple.

Before attempting to replace the battery, abide by CyberPower's safety recommendations. These include turning off and unplugging any connected equipment to the UPS before turning off and disconnecting the UPS from the AC power source.

By unfastening the screw holding the battery cover to the UPS, you can slide the battery cover open and set it aside. Slide the new battery into the compartment and connect the wires after removing the old battery and removing the battery connectors. Put the battery cover back on and tighten it with the screw.

Voltage: 12v
Capacity: 7ah @ 20Hr
Terminals: T2 6.35mm Spade
Chemistry: AGM, VRLA, Sealed Lead, Pb.

The dimensions of each battery in this pack of two is below, it should fit pretty snug in the UPS:
Length = 151mm or 5.94-inches
Width = 65mm or 2.55-inches
Height = 94mm or 3.7-inches.