RBP0014 sealed lead battery pack for PR750ELCD CyberPower UPS
Replacement RBP0014 sealed lead rechargeable battery pack for CyberPower PR750ELCD UPS machine, delivered from UK warehouse at low cost
The Professional Tower Series, created for computer rooms and server rooms, uses a line-interactive topology with the Automatic Voltage Regulation (AVR) function to provide stabilised AC power output with Pure Sine Wave to guarantee high power quality. The UPSs have hot-swappable battery packs, so maintenance can be done without affecting power. The products can also easily control and monitor the UPS system thanks to compatibility with power management software.
- CyberPower PR750ELCD battery
- CyberPower RBP0014 battery
Pack of two batteries for easy installation into PR750ELCD CyberPower UPS system
Maintenance for new RBP0014 battery in PR750ELCD UPS
These premium replacement batteries are designed for uninterruptible power supply devices and should last between two and five years, per CyberPower recommendations. Because it all depends on how well-maintained and how hard the batteries are pushed, the range is so broad. You can help the UPS, which naturally has its charging system, in a few ways. First, after installation, make sure to run the UPS with no load. Avoid using the UPS as a table as well. Maintaining the vents open and in a well-ventilated area is a good idea. Last but not least, try to keep the load below 40% if at all possible.
RBP0014 and PR750ELCD Installation
Here are instructions on how to change the batteries in your PR750ELCD UPS:
Firstly, turn off and unplug all equipment connected to your device, then turn it off and unplug from the power source. Remove the front panel of the UPS, then pull out both round knobs to remove the battery compartment. Disconnect the wires, remove the batteries and install the new batteries connecting the wires back as they were. Secure the cover again by doing everything in reverse.
You will be able to download the user manual for the PR750ELCD on our downloads tab, which will have more detailed information.
Voltage: 12v
Capacity: 7ah @ 20Hr
Terminals: T2 6.35mm Spade
Chemistry: AGM, VRLA, Sealed Lead, Pb
The dimensions of each battery in this pack of two are below. It should fit pretty snug in the UPS.
Length = 151mm or 5.94-inches
Width = 65mm or 2.55-inches
Height = 94mm or 3.7-inches