MGE Ellipse ASR 600 USBS IEC replacement UPS battery set AGM sealed
Replacement MGE Ellipse ASR 600 USBS IEC rechargeable batteries, valve regulated sealed lead acid non-spillable safe UPS system battery pack, absorbed glass mat AGM cells low competitive price
Here you will find we have hopefully supplied sufficient detailed information to help you make an informed decision on the purchase of a new set of batteries for your MGE Ellipse ASR 600 USBS IEC, the onboard energy storage which give you the required runtime back up facility also helps to filter and smooth out the mains input supply before releasing a clean version on to your valuable equipment behind it without surges and is powered by way of 12-volt cells, this system comes with 1 x 12v batteries and that is what we are offering on this page which of course as would be required, rechargeable, they are safe to use, not-hazardous, not-spillable AGM and VRLA type batteries, more detailed information about the fine qualities of them can be found below
- MGE Ellipse ASR 600 USBS IEC battery replacement
The batteries that you receive from us will be almost fully charged, but your UPS will still need to complete a full service charge, with this in mind it will follow that there will be a short period of time that the system is unable to offer its full runtime protection while it is doing this, you will find its better to allow the system to run without load to start while it completes the first charge to reset the new battery energy level
A reasonable life span of batteries is between two to five years, this is not a set rule though life span will change depending on how they are used, do not pile books or files on top of it, it needs good ventilation, batteries will get very hot, if the vents are blocked it will get hotter, the hotter it gets the shorter the life, If you can keep the constant load below 40% the batteries will end up lasting longer, a high load will be at the expense of the overall life expectancy of the cells
This type of battery is valve regulated sealed lead acid, they need no maintenance, they will not spill and can be mounted on the side so suitable to be used in rack or tower UPS systems and not-hazardous so safe for mission critical installations
Ensure that you order the right battery by checking the code on your UPS and comparing it to the information here, so many are very similar so mistakes are often made, these hot swap capable batteries are recyclable, more information on this can be found at the bottom on this page on our recycling link.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = VRLA, AGM
Hot swap capable
There are a total of 1 batteries for use in the MGE Ellipse ASR 600 USBS IEC UPS we have listed the size of each battery below
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below
