Eaton Powerware PW 9125 1500 replacement UPS battery set AGM
Replacement Eaton Powerware PW 9125 1500 sealed lead battery pack, rechargeable UPS system valve regulated batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Your UPS is there to protect vital equipment behind it, when the light is telling you it's time to replace the battery then its probably not a good idea to ignore it, it is a very easy job and is well worth the investment of a new battery to protect your valuable data, below is the details of battery replace for the Eaton Powerware PW 9125 1500, it is powered by way of internal energy storage source these batteries are used to filter the mains supply and output a clean version without any spikes the cells are 12v cells, and comes with 4 x 12-volt batteries and that is what this offer is for these are rechargeable, non-spillable safe AGM, VRLA and capable of deep cycling which is vital in this sort of installation where they are constantly being used 24-hours a day
- Eaton Powerware PW 9125 1500 battery replacement
The batteries will come out to you almost fully charged, but the system will still want to finish off the full charge, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, while it may not be convenient it is best to run without load to start so it can fully reset itself to the new energy level
You would expect these kind of batteries to last between two to five years in this kind of device, this can vary greatly on conditions, using the system as part of the office furniture is not the best idea, it needs ventilation, the batteries will get very hot as they are working hard 24-hours a day, the more heat the shorter their life, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span
These batteries are very tough and can be mounted on the side without any issues which means they can be used in tower or rack mountable situations, they are the recommended VRLA type and not-hazardous so safe for use in critical environments
Check the code on your UPS to ensure you are ordering the correct battery set, the size of the batteries are also specified below if you are unsure, many of the codes on UPS systems are similar
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
In this pack there is 4 rechargeable and recyclable batteries for the Eaton Powerware PW 9125 1500 we have listed the size of each battery below
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
We are also able to offer this size battery as a 9-amp hour version, its exactly the same physical size and will slip straight in to the same cavity except it will offer a longer runtime and will probably last longer overall saving you money in the long run, link to this alternative is a bit further down the page
