Eaton Powerware PW9120 BAT 1000 EBM UPS battery replacement
Replacement Eaton Powerware PW9120 BAT 1000 EBM non-spillable sealed lead acid valve regulated UPS system batteries, AGM and VRLA that can be mounted on its side offered direct from warehouse at low cost
Below is the details of the batteries your will require to replace in your UPS system for the Eaton Powerware PW9120 BAT 1000 EBM, it is powered by way of internal energy storage source these batteries are used to filter the mains supply and output a clean version without any spikes the cells are 12v cells, and comes with 6 x 12-volt batteries and that is what this offer is for which of course are rechargeable, sealed not-spillable safe AGM and VRLA offering a long life as these business machines will take a lot of work over the years
- Eaton Powerware PW9120 BAT 1000 EBM battery replacement
We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, while it may not be convenient it is best to run without load to start so it can fully reset itself to the new energy level
In this kind of device you would expect the batteries to last somewhere between two to five years, this will be very dependent on the use and the way the system is stored, good ventilation, if it's in a office do not use it as a book shelf, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
Batteries will require no maintenance, they are AGM and VRLA, they are also not-hazardous, they can be used in rack mountable or tower systems as they will not leak if mounted on the side
Check the code on your UPS to ensure you are ordering the correct battery set, the size of the batteries are also specified below if you are unsure, many of the codes on UPS systems are similar
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
There is 6 quality batteries for the Eaton Powerware PW9120 BAT 1000 EBM the dimensions of the individual battery pack are as follows
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
If you want to get the most from your UPS why not upgrade the battery to a 9ah version, it has the same dimensions and can replace the 7ah original without issue with the benefit of a longer runtime, the link to this option is below
