Powersonic PS1252 replacement 12-volt battery sealed lead AGM
Replacement Powersonic PS1252 non-spillable sealed lead acid valve regulated 12-volt 4.5ah batteries, seen in alarm systems, emergency lighting, UPS and portable devices, both AGM & VRLA, offered direct from warehouse at low cost
Below you will find we have listed relative information to help you properly consider the decision to buy new compatible replacement battery for your Powersonic PS1252, which has a energy storage capacity of 4.5-amp hours, they are used in quite a lot of different applications such as portable medical equipment, UPS systems, emergency lighting and even lawn mowers the cells are 12-volt and capable of deep cycling, they are of course rechargeable, non-hazardous AGM and VRLA cells so they are safe handle and to use around the home or in portable devices, more information about the qualities of the chemistry make up will be available below
- Powersonic PS1252 battery replacement
When your order is delivered to you your new batteries will be almost fully charged, but regardless of this you should still complete a charge them before first use, if the battery is being fitted in something like an UPS system then you can miss this step as the on board circuit will do a better job of charging it than you, it shouldn't take long, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, you may well just want to fit them and use the equipment, but do not miss this first step if needed, it's worth waiting until the first charge has completed and it may well contribute to over life span
It will probably not even be apparent to you at all but it will take a number charges, up to ten and associated use in your device before the battery is capable of receiving a full capacity charge, this is quite normal, each time you have used your battery in a portable device then you should put it back on charge as soon as you can, do not leave it sitting in a semi discharged state, never try to discharge the batteries, it will not rejuvenate them, with this type of technology it will only mean a shorter life, there may well be extended periods where the batteries are not being actively used, if so ensure they are charged fully beforehand and then recharged every 4 to 6-weeks but do not leave on the charger for more than 24-hours at a time
These 12-volt batteries are very resilient and can be mounted on the side without any issues so suitable for use in portable devices, deep cycle capable which of course is essential in electric powered devices, no leaking, which means they can be used indoors or medical environments, they are the recommended VRLA type and benefit from AGM technology they are not-hazardous so safe
We have provided the information here only as a guide, you need to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the wisest thing to do, These 12-volt 4.5ah batteries are made primarily of lead which is easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 12-volts
Capacity = 4.5Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
This offer is for a total of 1 ready to install batteries for the Powersonic PS1252 the physical size of the individual batteries are as follows
Length = 90mm or 3.54-inches
Width = 70mm 2.75-inches
Height = 101mm or 3.97-inches
Battery layout - from chart below = 1
We can also offer this battery size as a extended 5ah, it will directly replace this one meaning more energy per charge, it's the same physical size, the link to this option will be just a little bit further below
