6000 Plus infusion pump, 7 battery 3.2-amp VRLA sealed 12-volt.
Replacement 6000 Plus infusion pump, 7 non-spillable 12-volt sealed lead acid valve regulated 3.2-amp hour batteries, AGM and VRLA can be mounted on its side offered direct from warehouse at low cost.
This page has been created to offer more information on a replacement battery for the 6000 Plus infusion pump, 7 which is 12-volts with a 3.2ah capacity sealed lead and of course rechargeable, these sealed AGM and VRLA cells will not leak and suitable for use in portable devices is required.
- 6000 Plus infusion pump, 7 battery
This is a AGM and VRLA battery, it is safe to use indoors as it is not-hazardous, it needs no maintenance throughout its life, except of course charging, no topping up with fluid, will not leak, can be mounted on its side, often used in portable devices as well fixed machines.
Please note the information that we have supplied here from available resources for this compatible sealed battery is purely that, all the specifications are listed here as well so you can check the size and your personal requirements before ordering.
Voltage = 12-volts
Capacity = 3.2Ah @ 20Hr
Chemistry = AGM, VRLA.
There is one quality batteries for the 6000 Plus infusion pump, 7 the overall size of the batteries are
Length = 134mm or 5.27-inches
Width = 67mm or 2.63-inches
Height = 61mm or 2.4-inches
T1 Flat terminals, 4.75mm or 0.187 inch wide.
Your new battery will be delivered to you pretty much fully charged, but unless it's going in a device with its own built in always connected mains supply charging circuit then you should still give a it a full charge before first use, recharge after every use and if not using it for long periods then again every 4-weeks, save money by looking after your battery, keep it charged.
