Physio Control 3 Cardiac Monitor rechargeable 6v battery 1.2ah sealed
Replacement Physio Control 3 Cardiac Monitor battery pack, rechargeable sealed lead non-hazardous 6-volt 1.2-amp hour batteries that will not leak, VRLA, AGM at low competitive prices
On this page you will find we have listed all of the required data to support your consideration of a purchase of a new replacement compatible battery for the Physio Control 3 Cardiac Monitor, they are 6-volt with 1.2ah of energy storage and capable of deep cycling, rechargeable and recyclable, the main component by far in the cells is lead this means they are a environmentally friendly as can very easily be made into something else, maybe another battery at the end of their life and the time comes for recycling, more information on this can be found on our recycling page
- Physio Control 3 Cardiac Monitor battery replacement
When your order is delivered to you your new batteries will be almost fully charged, but regardless of this you should still complete a charge them before first use, this will not be necessary only if being fitted in something that is always connected to the mains like an alarm system which will do the job for you, the charger will have LED lights which will indicate whether it is still charging or not, you only need to charge them until they are ready, probably not very long at all, you may well just want to fit them and use the equipment, but do not miss this first step if needed, it's worth waiting until the first charge has completed and it may well contribute to over life span
While is not something that most will even notice but it will take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, when you have used your portable devices then put the batteries back on charge, you do not want to allow them to sit in a partially discharged state, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours
These 6-volt batteries are very resilient and can be mounted on the side without any issues so suitable for use in portable devices, deep cycle capable which of course is essential in electric powered devices, no leaking, which means they can be used indoors or medical environments, they are the recommended VRLA type and benefit from AGM technology they are not-hazardous so safe
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6v 1.2ah batteries are made mainly of lead which is easy to recycle and transform into another product so therefore environmentally friendly, more information regarding recycling will be found at a link at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM
This set contains a total of 1 rechargeable batteries to replace the Physio Control 3 Cardiac Monitor here is the dimensions of a single battery
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
