R&D 5051 replacement 6-volt battery sealed lead AGM rechargeable
Replacement R&D 5051 rechargeable batteries, 6-volt 1.2ah valve regulated sealed lead acid non-spillable safe battery pack, absorbed glass mat AGM cells, low competitive price
Below you will find we have listed detailed information to help you consider the decision to buy new compatible replacement battery for your R&D 5051, which has a energy storage capacity of 1.2-amp hours, the cells are 6-volt and capable of deep cycling, which as you would expect and require, rechargeable, they're sealed and will not spill any liquids, so safe to handle and use indoors, they are AGM and VRLA offering a long life, more information on the chemistry of them will be found below
- R&D 5051 battery replacement
Even though the batteries you receive from us will be almost fully charged you should still complete a full charge before first use, this will not be necessary only if being fitted in something that is always connected to the mains like an alarm system which will do the job for you, there should be no need for many hours, it will probably not take very long at all, just until your charger indicates they are ready, this will of course depend on the charger capabilities, you may well be impatient and use the equipment without charging but it's worth waiting until its fully charged and will help extend overall life expectancy
Most users will not even notice but it will take a number of charges and associated use in your equipment before they are capable of accepting a full capacity charge, this is quite normal and part of the conditioning process, once you have used your portable equipment then put the batteries back on charge, do not let them sit in a partially discharged state for any longer than absolutely necessary, never try to discharge the batteries all the way down, doing so with this type of battery will only reduce the life span and cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
So many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, these 6v 1.2ah batteries are made mainly of lead which is easy to recycle and transform into another product so therefore environmentally friendly, more information regarding recycling will be found at a link at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = VRLA, AGM, sealed lead, Pb
There are a total of 1 batteries to replace the R&D 5051 the physical dimensions of each battery is
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
