Vision CP612 6-volt 1.2ah battery replacement rechargeable AGM
Replacement Vision CP612 rechargeable battery pack, valve regulated sealed lead 6-volt 1.2-amp hour batteries with VRLA and AGM technology, at low competitive price direct from warehouse

Please find below on this page the relevant details to help you consider the decision of purchasing a new compatible replacement battery for your Vision CP612, it is 6-volt with a1.2 amps of energy storage and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below

• Vision CP612 battery replacement

The batteries will be delivered with a very good charge in them, but even so you should still charge before using for the first time, the only time you do not need to do this is if it's going into something with its own always connected power supply, for example a alarm system, as this will do the job of charging for you, the charger will have LED lights which will indicate whether it is still charging or not, you only need to charge them until they are ready, probably not very long at all, you may well just want to fit them and use the equipment, but do not miss this first step if needed, it's worth waiting until the first charge has completed and it may well contribute to over life span

It's not always apparent but it will take up to ten charges combined with use in your chosen device before a full capacity charge can be achieved, this is just a normal part of the conditioning process, letting the batteries sit in a discharged state, even partially is not a good idea, so if being used in a portable device as soon as you have used them put them back on charge, do not try to fully discharge the batteries, it will not rejuvenate them, it will reduce the lifespan and cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than 24-hours

These batteries will require no general maintenance, no topping up with fluid as it has none, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices

We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6-volt 1.2-amp hour batteries are recyclable, the main component is lead which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link

Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA

In this pack there are a total of 1 batteries to replace the Vision CP612 here is the dimensions of a single battery
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1