R&D 5064 6-volt 3.2ah battery replacement rechargeable AGM
Replacement R&D 5064 sealed lead battery pack, rechargeable and compact valve regulated 6-volt 3.2ah batteries, used as battery backup or in portable devices, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Here you on the page below will find we have compiled detailed information which should be enough to help you make a informed decision on the purchase of new replacement compatible battery for your R&D 5064, which can be seen in medical devices portable and fixed as well as alarm systems are 6-volt and 3.2ah and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below
- R&D 5064 battery replacement
After you have made and unpacked your new battery from us you will note that they will have a good charge in them, regardless of this you should still complete a full maintenance charge before first use, this will not be necessary only if being fitted in something that has its own built in charger that is always connected to the mains like an alarm system which will do the job for you, the charge time will depend on your charger but as its almost fully charged it will not be long, just leave it on until it indicates its finished, do not just install and use without this initial charge, unless the situation is as stated above, doing so can shorten expected life span, it's well worth doing
While is not something that most will even notice but if being used in a portable piece of equipment it could take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, you should fully charge your batteries as soon as you can after every use if they are being used in a portable device, do not leave them sitting in a semi discharged state any period unless necessary, do not attempt to deliberately discharge the batteries, it will not rejuvenate them, in fact the opposite, it will only do them harm and will reduce the life span, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours
These batteries will require no general maintenance, no topping up with fluid as it has none, the acid is suspended within a glass matting between the plates so will not spill, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices
The information we have provided on this page should only be used as a guide, you should carefully check before ordering as many are very similar, if still in doubt you can look at your old battery, take a note of the dimensions and anything that may be written on the side of them, this will always be the best way, we have also included the physical dimensions on this page so you can confirm, this 6-volt 3.2ah battery is as you would expect recyclable, the main component is lead, more detailed information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
In this set there is 1 quality batteries for the R&D 5064 the dimensions of the individual battery pack are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
