Steatite BR01C7BD03 6-volt battery replacement sealed AGM VRLA
Replacement Steatite BR01C7BD03 non-spillable small and compact sealed lead acid valve regulated 6-volt 3.2ah batteries, often used as backup or in portable devices AGM and VRLA, offered direct from warehouse at low cost
We have tried to list here, and hopefully succeeded on this page all the relevant information to help you make the decision of purchasing a new replacement compatible battery for your Steatite BR01C7BD03, this type of battery is often seen in portable devices including medical equipment as well as backup for alarm systems the 6v cells have a energy storage capacity of 3.2-amp hours. they are also capable of deep cycling, which are, as would be of course be required, rechargeable, they are safe to use indoors they will not spill, non-hazardous, AGM and VRLA construction of cells, much more information about the qualities of these unique chemistries can be found below
- Steatite BR01C7BD03 battery replacement
After placing you and receipt of your order you will note that the batteries will be almost fully charged when received, but you should still maintain a full charge before first use, if it's going into a device that is always connected to the mains and has its own charging circuit like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, you do not need to leave it on for hours on end its almost fully charged, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, try to make sure you do not miss the initial charge (unless of course being fitted in a device with own circuit as stated above), doing so may well reduce overall life expectancy
Unless you are a very extended user you will probably not even notice that it can take a number of charge and use in your equipment before a full capacity charge is achieved, this is all part of the conditioning process and quite normal, letting your new batteries sit in a discharged state, even partially is not a good idea, so if being used in a portable device as soon as you have used them put them back on charge, never go out of your way to deliberately discharge fully, this type of technology is not suitable for that kind of treatment, this will only reduce overall life span, If there are extended periods where the batteries are not being used then ensure they are fully charged beforehand then recharged every four weeks but you should not leave on the charger for more than 24-hours
These 6-volt batteries are valve regulated and AGM or absorbed glass mat, not need for any liquid as the acid is held within the glass mat, this means they will not spill and not-hazardous so safe for use around the home and or portable equipment, they are deep cycle which would be required in this sort of application
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6v 3.2ah batteries are mainly constructed using lead which can easily be recycled, more information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead, AGM, VRLA
There is 1 rechargeable lead acid batteries for the Steatite BR01C7BD03 the physical size of the individual batteries are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
