Cutter Labs 70040 6v 3.2ah battery replacement sealed lead VRLA AGM
Replacement Cutter Labs 70040 batteries, rechargeable valve regulated sealed lead 6-volt 3.2-amp hour compact non-spillable battery, can be used in portable devices, available at low competitive price direct from warehouse
Please find below the information on this page that we have compiled so you can make a educated decision on the purchase of a new replacement compatible battery for the Cutter Labs 70040, it is 6-volt with 3.2-amps of energy storage quite seen portable medical devices and alarm systems it is capable of deep cycling, as you would expect they are rechargeable and not-hazardous, they will not spill so safe to be handled and for use indoors as well as more portable applications, they are also recyclable and environmentally friendly, more information on recycling can be found on our recycle page
- Cutter Labs 70040 battery replacement
This sealed lead battery that you obtain from us will be almost fully charged, but you should still charge them fully before first use, this will not be necessary only if being fitted in something that has its own built in charger that is always connected to the mains like an alarm system which will do the job for you, just charge them until your charger LED lights indicate that they are ready, it will probably not take very long, do not be impatient, wait until this first charge has completed before contemplating using the equipment, it will possibly contribute to overall battery life
Unless you are a very extended user you will probably not even notice that it can take a number of charge and use in your equipment before a full capacity charge is achieved, this is all part of the conditioning process and quite normal, allowing your new batteries to sit without any charge in them is not a certainly not a good idea so it follows that if using them in a portable device as soon as you have finished using it put it back on charge, do not go out of your way to try discharge the batteries fully, this will not extend the life of them, quite the contrary, it will reduce life span quite drastically so cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than 24-hours
This type of battery is valve regulated lead acid, VRLA for short, they still have acid but its trapped between a glass matting, this is why they are also called AGM or absorbed glass mat, you will never to need to top them up with fluid, if fact you cannot as they are sealed, they are not-hazardous and can safely be used indoors or in portable devices with no fear of leakage
You should confirm the code on your old battery carefully, there are many that are very similar so you want to order the correct one, check the dimensions and take note of anything written on the side of them, we have also included the physical dimensions below so you can make certain you are ordering the correct one, these 6-volt 3.2ah batteries are recyclable, the overlaying main constructed content is lead which is very easily transformed into another useful product, maybe even another battery, more information about recycling can be found on our recycling page, link to which is at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM
This set contains 1 rechargeable and recyclable batteries for the Cutter Labs 70040 the physical size of the individual batteries are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
