Cutter Labs Infusion Pump rechargeable 6v battery 3.2ah sealed lead
Replacement Cutter Labs Infusion Pump non spill compact 6-volt 3.2-amp hour battery pack, safe can be used in portable devices or energy backup, valve regulated sealed lead VRLA AGM rechargeable batteries at low cost
Please find below printed on this page sufficient relevant details to help you consider the decision of purchasing a new compatible replacement battery for your Cutter Labs Infusion Pump, these 6-volt batteries are often seen in portable medical equipment or back up in alarm systems, they are deep cycle capable with a energy storage of 3.2-amp hours, being AGM and VRLA they are rechargeable, they are safe to be handled and to use indoors or in portable devices, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- Cutter Labs Infusion Pump battery replacement
Upon receipt of your order from us the batteries will be almost fully charged but even so you will still need to complete a charge before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, you only need to complete the charge until the charger indicates that its ready, it probably will not take long but it is very important so not a step you should overlook, while you may well be tempted just to fit without charging if it's going in a portable device its worth completing the charge first as it may well extend the life of them
It's not something that most will even notice but if being used in a portable device it may take a few charges and use in the equipment before a full capacity charge can be reached, it's all part of the normal conditioning process, you should fully charge your batteries as soon as you can after every use if they are being used in a portable device, do not leave them sitting in a semi discharged state any period unless necessary, you cannot rejuvenate this kind of battery by deliberately running them down, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours
These 6-volt batteries are valve regulated and AGM or absorbed glass mat, not need for any liquid as the acid is held within the glass mat, this means they will not spill and not-hazardous so safe for use around the home and or portable equipment, they are deep cycle which would be required in this sort of application
Check the information carefully to ensure you are ordering the correct battery as many of them have very similar codes, if in doubt the dimensions of the batteries are probably your best guide and take note of anything that may be written on the side of them, the size of is also specified below so you can confirm, these 6-volt 3.2ah batteries are made mainly of lead which is deemed easy to be recycled, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead acid, VRLA, AGM
You will find a total of 1 quality lead acid batteries for the Cutter Labs Infusion Pump the dimensions of the individual battery pack are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
