Lintronics NP266 replacement 6-volt battery sealed lead AGM VRLA
Replacement Lintronics NP266 battery pack, rechargeable compact 6v 3.2ah sealed lead acid, safe non-spillable so can be used in portable equipment, valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Below you will find we have hopefully listed all of the relevant information you will need to help you consider the decision on the purchase of a new compatible replacement battery for your Lintronics NP266, this type of battery is often seen in portable devices including medical equipment as well as backup for alarm systems the 6v cells have a energy storage capacity of 3.2-amp hours. they are also capable of deep cycling, which are rechargeable, they are safe to handle and can be use indoors and in mobile applications, not-hazardous and will not spill, more information on their chemistry make up will be found below
- Lintronics NP266 battery replacement
This sealed lead battery that you obtain from us will be almost fully charged, but you should still charge them fully before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, there should be no need for many hours, it will probably not take very long at all as its almost fully charged already, just until your charger indicates they are ready, this will of course depend on the charger capabilities, do not just install and use without this initial charge, unless the situation is as stated above, doing so can shorten expected life span, it's well worth doing
If being used in a portable device it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, each time you have used your battery in a more portable device then you should put it back on charge as soon as you can, it is not wise to leave it sitting in a semi discharged state for any longer than necessary, never go out of your way to deliberately discharge fully, this type of technology is not suitable for that kind of treatment, this will only reduce overall life span, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
Please note you should use all the information on this page only a guide, while we have tried very hard here to assist you in getting the correct battery, it should be noted that there are many very similar codes, if you are not sure you should always double check what you have before ordering, this may also give you the opportunity to see how easy it is going to be to change them, take note of the dimensions and anything written on the side of them, all the physical sizes are listed on this page, as these 6-volt 3.2ah batteries are manufactured mainly from lead they are recyclable, this is of course environmentally friendly, more information about recycling can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = Pb, sealed lead, VRLA, AGM
In this pack there is 1 rechargeable and recyclable batteries for the Lintronics NP266 the physical dimensions of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
