Panasonic LCR063R2PU rechargeable 6-volt 3.2ah battery replacement
Replacement Panasonic LCR063R2PU rechargeable batteries, small and compact 6-volt 3.2ah valve regulated sealed lead acid non-spillable safe battery pack, can be used in portable devices or as power backup, absorbed glass mat AGM cells, low competitive price
On this page you will find we have hopefully listed all of the required data for you to make a educated decision to support your consideration of a purchase of a new replacement compatible battery for the Panasonic LCR063R2PU, this type of battery is often seen in portable devices including medical equipment as well as backup for alarm systems the 6v cells have a energy storage capacity of 3.2-amp hours. they are also capable of deep cycling, they are of course rechargeable, very important requirements in this type of installation, they will not spill and not-hazardous so safe to be handled and for use indoors or in portable equipment, the cells are AGM and VRLA, more information about the qualities of this sort of chemistry can be found below
- Panasonic LCR063R2PU battery replacement
This sealed lead battery that you obtain from us will be almost fully charged, but you should still charge them fully before first use, if the battery is being fitted in something with its own built in always connected mains supply like an alarm system then you can miss this step as it will do a better job of charging it than you, the charger will have LED lights which will indicate whether it is still charging or not, you only need to charge them until they are ready, probably not very long at all, you may well be impatient and want to use the equipment without charging for the first time but it's worth waiting until its fully charged and will help extend the overall life expectancy
It's not always apparent but if you are using the battery in device that requires user action for the charging of it that it may take up to ten charges combined with use in your equipment before a full capacity charge can be achieved, this is just a normal part of the conditioning process, if being used in a portable device then you should make sure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, do not try to attempt to fully discharge the batteries, it will not rejuvenate them, in fact the opposite, it will reduce the lifespan and cost you money in the long run, If there are extended periods where the batteries are not being used then ensure they are fully charged beforehand then recharged every four weeks but you should not leave on the charger for more than 24-hours
These batteries are deep cycle capable, which is essential in this type of application, the VRLA and AGM cells will not leak as the acid is combined within a glass matting so no liquid, not-hazardous so suitable for travelling, there is no maintenance required, except of course charging which we have covered on this page.
We have provided the information here purely as a guide, it would be wise to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the best thing to do, these 6v 3.2ah batteries are mainly constructed using lead which can easily be recycled, more information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
There are 1 recyclable lead batteries for the Panasonic LCR063R2PU the overall dimensions of each battery are
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
