Potter Electric Sign NP266 replacement 6-volt battery sealed lead AGM
Replacement Potter Electric Sign NP266 battery pack, rechargeable compact 6v 3.2ah sealed lead acid, safe non-spillable so can be used in portable equipment, valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Please find below the information on this page that we have compiled so you can make a educated decision on the purchase of a new replacement compatible battery for the Potter Electric Sign NP266, it is 6-volt with 3.2-amps of energy storage quite seen portable medical devices and alarm systems it is capable of deep cycling, which as you would expect and would require in this type of application, rechargeable, they're sealed and will not spill any liquids, so safe to handle and use indoors as well as more mobile use, they are AGM and VRLA offering a long life, more information on the chemistry of them will be found below
- Potter Electric Sign NP266 battery replacement
Even though the batteries you receive from us after placing your order will be almost fully charged you should still complete a full charge before first use, this will not be necessary only if being fitted in something that has its own built in charger that is always connected to the mains like an alarm system which will do the job for you, the period of this initial charge before first use need only be until the charger states it is ready, probably not very long at all, this first step is important so please do ignore it, unless of course as otherwise stated above, do not use without this initial charge, doing so can shorten expected life span
You probably will not even notice it but if you are using the battery in a device that needs outside assistance for charging that it will take a few charges and use in your equipment before you are able to receive a full capacity charge in your batteries, this is quite a normal part of the conditioning process, you should fully charge your batteries as soon as you can after every use if they are being used in a portable device, do not leave them sitting in a semi discharged state any period unless necessary, do not try to attempt to fully discharge the batteries, it will not rejuvenate them, in fact the opposite, it will reduce the lifespan and cost you money in the long run, there may be many reasons for the equipment not be used on a regular basis, if there are protracted periods where this is the case then ensure the batteries are charged before hand and then topped up every four weeks but do not leave on a charger for more than 24-hours at a time
These 6-volt batteries are valve regulated and AGM or absorbed glass mat, not need for any liquid as the acid is held within the glass mat, this means they will not spill and not-hazardous so safe for use around the home and or portable equipment, they are deep cycle which would be required in this sort of application
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6-volt 3.2-amp hour batteries are recyclable, the main constructive component is lead or Pb which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = sealed lead, AGM, VRLA
This set contains a total of 1 recyclable lead batteries for the Potter Electric Sign NP266 the overall size of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
