Power Star batteries GB626 6-volt battery replacement sealed AGM VRLA
Replacement Power Star batteries GB626 battery pack, rechargeable compact, non-spillable sealed lead non-hazardous 6-volt 3.2-amp hour batteries that will not leak, can be used in portable equipment, VRLA, AGM at low competitive prices
Below you will find we have hopefully listed all of the relevant information you will need to help you consider the decision on the purchase of a new compatible replacement battery for your Power Star batteries GB626, which has a energy storage capacity of 3.2-amp hours, this size battery is often used in medical devices, portable and fixed and also commercial and home alarm systems as well as other uses, the cells are 6-volt and capable of deep cycling, they are safe to be handled and to use indoors or in portable devices as well of course as rechargeable they are made for this kind of application, they are the required VRLA with AGM technology (more information about the qualities of the chemistry of them will be found below) they are recyclable and very environmentally friendly, see our recycle page for details
- Power Star batteries GB626 battery replacement
After placing your order and receiving your new battery from us you may will note that they have a good charge in them, but you should still charge it fully before using for the first time, the only time you do not need to do this is if it's going into something with its own always connected power supply and charging circuit, for example a alarm system, as this will do the job of charging for you, the charge time will depend on your charger but as its almost fully charged it will not be long, just leave it on until it indicates its finished, while you may well be tempted just to fit without charging if it's going in a portable device its worth completing the charge first as it may well extend the life of them
Most users will not even notice but if being used in a more mobile device it may take a number of charges and associated use in your equipment before they are capable of accepting a full capacity charge, this is quite normal and part of the conditioning process, each time you have used your battery in a more portable device then you should put it back on charge as soon as you can, it is not wise to leave it sitting in a semi discharged state for any longer than necessary, never go out of your way to deliberately discharge fully, this type of technology is not suitable for that kind of treatment, this will only reduce overall life span, there may be many reasons for the equipment not be used on a regular basis, if there are protracted periods where this is the case then ensure the batteries are charged before hand and then topped up every four weeks but do not leave on a charger for more than 24-hours at a time
These 6-volt batteries are sealed lead valve regulated or VRLA and further benefit from using AGM technology, this means they will not spill so can be used indoors or in portable equipment without fear of leakage, capable of deep cycling as would be essential in this type of application, they are not hazardous
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6-volt 3.2-amp hour batteries are recyclable, the main constructive component is lead or Pb which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = absorbed glass mat, AGM, VRLA
There is 1 batteries to replace the Power Star batteries GB626 the physical dimensions of each battery is
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
