Weed Eater Clipstick 2 6v battery replacement 7ah VRLA AGM sealed
Replacement Weed Eater Clipstick 2 6v 7ah battery pack, rechargeable sealed lead acid, safe non-spillable valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Please find below on this page the relevant details to help you consider the decision of purchasing new batteries to replace the Weed Eater Clipstick 2 compatible deep cycle batteries which are 7amp hour and 6-volt batteries, rechargeable, seen in many different types of device from UPS systems to childrens ride on toy cars, they are non-spillable and not-hazardous so it's safe to handle them and use indoors, they have a AGM and VRLA type of cell, more information on the chemistry will be found below
- Weed Eater Clipstick 2 battery replacement
The batteries that you obtain from us will be almost fully charged, but you still need to charge them fully before first use, the time of the first charge will be dependent on the charger, just leave it on until its finished, it will probably not take very long, do not just install and go without this initial charge, doing so can shorten expected life span, it's well worth doing
Most users will not even notice but it will take a number of charges and associated use in your equipment before they are capable of accepting a full capacity charge, this is quite normal and part of the conditioning process, as soon as you after each use put them back on charge, do not allow them to sit in a discharged state, do not attempt to discharge the batteries fully, this can reduce life span quite drastically so cost you money in the long run, they may be protracted periods where the batteries are not being used, if this is the case ensure they are fully charged first, then top up every four weeks but do not leave on a charger for more than four weeks
These 6-volt batteries are AGM ( absorbed glass mat ) and VRLA ( valve regulated lead acid ) they are deep cycle and not-hazardous so suitable for use indoors, they will not leak all features that make them useful for use in this kind of application, they of course do not require any maintenance
Check the code on your old battery carefully to ensure you are ordering the correct one as many of them have very similar names of codes, if in doubt you could check the dimensions of the batteries and take note of anything that may be written on the side of them, the size of the batteries are also specified below so you can confirm, the batteries themselves have a very high lead content so they are recyclable, more detailed information about recycling lead batteries can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 7Ah @20Hr
Chemistry = VRLA, AGM
This set contains 1 ready to install batteries for the Weed Eater Clipstick 2 we have listed the size of each battery below
Length = 151mm or 5.94-inches
Width = 34mm 1.33-inches
Height = 94mm or 3.7-inches
Battery layout - from chart below = 1
