Mangar Airflo Mk3 battery air compressor replacement 12v.
Replacement Mangar Airflo Mk3 air compressor battery pack, rechargeable sealed 12v batteries for this pump used with mobility cushions at low price direct from warehouse.
The Mangar Airflo Mk3 is a 12v system, unlike the Mk1 and Mk2, if you have come to this page looking for them then go to the bottom of this page where there will be links to them as they are 24v and require a different battery pack.
- Mangar Airflo Mk3 battery
Fitting of the battery is quite easy, take a look at your existing pack, it has a battery and rubber pad, just remove the cables from the old battery and put on the new, it may need taping to secure it and keep it tidy if the original was shrunk wrapped on, a two minute job.
You should fully charge your new battery before first use, or over night if in doubt, although your compressor with battery in place is capable of doing many lift before charging it is better to charge after very use, this type of battery does not like to be left in a discharged state, this will help prolong its life span.
The Mangar Airflow-Mk3 compressor is often used with the Mangar bathing cushion, Leg shifter, Handy Pillowlift, Surfer bather and Sit-U-Up.
The battery type is valve regulated sealed lead, VRLA, AGM.
it will not spill and can be mounted on its side.
It is not-hazardous.
Voltage = 12v
Capacity = 2.3ah amp-hour @20-Hr C20.
There is one battery in this set for the Mangar Airflo-Mk3, the size of this is:
length = 178mm - 7-inches
Width = 35mm - 1.37-inches
Height = 60mm = 2.36-inches.
You will find links below to the Mk1, Mk2 and Airflo-Plus which take a different battery set.