Ballymore-HW1-10 Company Scissor Lift battery replacement.
Replacement Ballymore-HW1-10 Company Inc Scissor Lift battery, rechargeable 6v flooded cell batteries for this 12v system at low prices direct from warehouse.
On this page we are offering you comprehensive details of replacement batteries for the Ballymore-HW1-10 Company Scissor Lift. The internal motors are powered via a 12v system, This is made up with two 6v batteries to store the energy required. These recyclable batteries are of course also rechargeable offering the best of both worlds with a environmentally and renewable power source.
- Ballymore Company HW1-10 battery
Flooded batteries will need a element of maintenance throughout their life. Make regular checks of the fluid level in them to ensure the plates are always covered. There will be loss of fluid over time by natural expulsion of gas which is why they are vented to allow this to escape. So it is essential that this fluid is replaced. They are very good at deep cycling and recyclable.
Please ensure that when they come to the end of their useful life that they are directed to a recycling centre for processing into another product. They are mainly made of lead or PB which is very capable of being reused over again many times, so very environmentally friendly, but only if you stop them going to landfill.
Voltage = 6-volts
Capacity = 230Ah @100Hr, 210Ah @20 Hr
Chemistry = Flooded cell
Approx total weight = 52-kilos
There is 2 batteries for use in the Ballymore-HW1-10 Company Scissor Lift the dimensions of the individual battery pack are as follows:
Length = 264mm or 10.23-inches
Width = 183mm or 7.09-inches
Height = 251mm or 9.76-inches
Total Height including terminals = 275mm or 11.4-inches.
If you have a requirement for a large number of these packs then contact us direct and we will furnish you with an individual quotation to suit your needs.
Ask about batteries
