BR1200ELCD-UK RBP0063 battery CyberPower UPS replacement.
RBP0063 replacement battery pack for BR1200ELCD-UK CyberPower Desktop BRIC UPS, rechargeable pair of 12V high-quality batteries for easy installation.
The BR1200ELCD-UK is a BRIC UPS from CyberPower and is the most powerful in this range, with 1200VA and 720W. When incoming utility power fluctuates, the UPS's built-in Automatic Voltage Regulation (AVR) function regulates low and over voltages, providing consistent and reliable power to connected devices. This will give the user 9 minutes at half load, which is enough time to properly power down any connected devices. There are six 3-pin UK plug sockets and a USB charging point. Other features include an LCD readout that clearly displays system information, including power, battery, and load status. It also has a simple and user-friendly interface that allows users to easily manage and monitor the entire system.
In order for the UPS to do its job correctly, it requires a pair of high-quality batteries, and that’s exactly what we are offering here. The replacement batteries are compatible with RBP0063, which is what CyberPower suggest.
- CyberPower BR1200ELCD-UK battery
- CyberPower RBP0063 battery
There are two batteries in this set as required for fitment.
Maintenance of RBP0063 battery
CyberPower and battery manufacturers would suggest these batteries will last three to five years when installed into a device like this. This can vary greatly depending on how the battery is cared for and how often it is used. Try to keep the load below 40%, the vents clean, and the temperature down. Following this advice will prolong the life of the batteries.
Installation of your new CyberPower BR1200ELCD-UK battery
Using only a screwdriver and five minutes of your time, you can remove the old battery and install the new one. First, turn off and unplug all equipment connected to the device, then unplug it from the main power source.
Flip the UPS upside down so you are looking at the bottom; you will notice screws holding a plate in place. Undo these to remove the battery cover. Remove the old battery with care and disconnect the two wires that are connected to each battery. Replace the batteries, reconnect the old wires, and insert them back into the UPS as before. Replace the battery cover and screw it down. To allow the batteries to adjust to their new surroundings, perform a cold start by pressing the UPS power button.
Environmentally friendly UPS batteries
They are recyclable because the main component of these batteries is lead (Pb), which can be easily converted into another product. The UPS machine has an energy-saving feature that is also beneficial to the environment. When these have served their purpose, please recycle them along with the batteries you are replacing at your local recycling centre.
Voltage: 12v x2
Capacity: 5Ah @20Hr
Terminals: T2 6.35mm Spade
Chemistry: AGM, VRLA, Sealed Lead, Pb.
Below are the dimensions of each compatible replacement battery in this pair for the BR1200ELCD-UK that will fit in your system.
Length: 90mm
Width: 70mm
Height: 101mm.
Ask about batteries
