CyberPower RBP0046 battery pack for UPS.
Compatible replacement for the CyberPower RBP0046 battery pack module, low-cost rechargeable batteries for UPS machines.
The CyberPower RBP0046 pack is the main power module used in a variety of small- and mid-range UPS units, providing them with the steady backup they need when the power flickers or cuts out completely. Your UPS manual will usually list the exact pack required, and in most cases, the RBP0046 is available in compact, plug-and-play units that are easy to maintain at home or in a small office.
Because this pack uses two batteries, the installation stays pleasantly simple. Larger UPS machines sometimes require a small mountain of batteries, but here you’re dealing with a quick, manageable swap. A basic screwdriver and about ten minutes is usually all it takes. Just make sure everything is disconnected first, and follow the usual safety steps before pulling out the old pack.
- CyberPower RBP0046 battery pack
Looking after the pack is mostly about keeping the UPS in a sensible environment. Avoid hot, cramped spots, make sure nothing blocks the airflow, and try not to let the UPS run right down unless absolutely necessary. Let it fully recharge after each outage, and run the built-in test from time to time. If you begin to notice the runtime slipping, it’s a good sign the pack is nearing the end of its life. Following these small habits helps keep the UPS dependable whenever the lights dip or the mains supply becomes unpredictable.
Voltage: 12v per battery
Capacity: 5Ah @20 hr
Chemistry: AGM, Sealed Lead, Pb
Terminals: T2 Spade - 6.35mm.
There are two batteries in this pack for the RBP0046; the dimensions of each are:
Length - 90mm
Width - 70mm
Height - 101mm.
Ask about batteries
