Eaton Powerware PW5119-1000 UPS battery pack replacement VRLA.
Replacement Eaton Powerware PW5119-1000 sealed lead-acid battery pack, rechargeable UPS system valve-regulated batteries, VRLA and AGM; they will not spill.
Below are the details of the batteries you will require to replace in your UPS system for the Eaton Powerware PW5119-1000. The power supply has batteries that clean up the mains electricity that is input, passing it through the cells before it reaches the equipment behind it. They are 6-volt cells, and it comes with 4 x 6-volt batteries, which is what this offer is for. These are rechargeable, non-spillable, safe AGM VRLAs that are capable of deep cycling, which is vital in this sort of installation where they are constantly used 24 hours a day.
- Eaton Powerware PW5119-1000 battery replacement
We will send you batteries that are almost fully charged. Your UPS will finish charging, which helps it reset the battery cell, so there will be a period when you do not have the full protection it can offer until it has completed this operation. While it may not be convenient, it is best to run without a load at startup so it can fully reset to the new energy level.
In this kind of device, you would expect the batteries to last somewhere between two to five years. This will depend heavily on use and how the system is stored. Ensure there is always adequate ventilation around the device; do not use it as a filing cabinet. If the batteries overheat, it shortens the lifespan. Also, do not overload. If you can keep the load below 40%, the system will be more than capable of going higher; it comes at the cost of working the battery cell harder, which means a shorter lifespan.
Voltage = 6-volts
Capacity = 10Ah @20Hr
Chemistry = AGM, VRLA
Hot-swap capable.
This offer is for a set of 4 quality lead-acid batteries for the Eaton Powerware PW5119-1000. Here are the dimensions of a single battery:
Length = 151mm
Width = 51mm
Height = 94mm.
Ask about batteries
