Eaton Powerware PW9120-2000 UPS battery replacement pack

Eaton Powerware PW9120-2000 UPS battery replacement pack.
Replacement Eaton Powerware PW9120-2000 battery pack, rechargeable VRLA, lead-acid UPS batteries, safe, not hazardous, at low prices, direct from the warehouse.

On this page, we offer comprehensive details on a set of replacement batteries for the Eaton Powerware PW9120 2000. It stores its required energy onboard using batteries, which filter the mains electrical input before outputting a clean supply, and it is powered by 12V cells.

• Eaton Powerware PW9120-2000 battery replacement

The batteries will arrive almost fully charged. However, the system will still want to finish off the full charge, during this period you should note that your system will not be able to offer you its full runtime protection until it has finished this task, while it may not be convenient it is best to run without load to start so it can fully reset itself to the new energy level.

You would expect these kinds of batteries to last between two to five years in this kind of device; this can vary greatly depending on conditions. Using the system as part of office furniture is not the best idea; it needs ventilation. The batteries will get very hot as they are working hard 24-hours a day, the more heat the shorter their life, keeping the load low will extend the life span, in a ideal world below 40%.

The battery type is AGM (absorbed glass mat) construction. They are also valve-regulated, can be used in tower- or rack-mounted UPS systems without fear of leakage, require no maintenance throughout the lifespan, and are non-hazardous, making them safe for indoor use.

Please double-check the code on your system to ensure you order the correct battery set. The batteries are mainly made from lead and are recyclable. More information on recycling is at the bottom of this page.

Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable.

This offer is for a set of 8 rechargeable lead-acid batteries for the Eaton Powerware PW9120 2000. The physical dimensions are as follows.
Length = 151mm
Width = 65mm
Height = 94mm.

To get the most from your UPS, consider upgrading to a 9Ah battery. It has the same dimensions and can replace the original 7Ah battery without issue, with the added benefit of longer runtime.