CAS Medical 901-BP Monitor rechargeable 6v battery 1.2ah sealed lead
Replacement CAS Medical 901-BP Monitor non-spillable sealed lead acid valve regulated 6-volt 1.2ah batteries, AGM and VRLA, offered direct from warehouse at low cost
On this page you will find we have listed all of the required data to support your consideration of a purchase of a new replacement compatible battery for the CAS Medical 901-BP Monitor, it is 6-volt with a1.2 amps of energy storage and capable of deep cycling, which are, as would be of course be required, rechargeable, they are safe to use indoors, non-hazardous, not-spillable AGM and VRLA type of cells, much more information about the qualities of these unique chemistries can be found below
- CAS Medical 901 BP Monitor battery replacement
The batteries you receive from us will be almost fully charged, but you should still charge them before first use, if it's going into a device that is always connected to the mains like a battery backup for monitoring or alarm system then you can miss this step as it will do it for you, it shouldn't take long, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, do not miss out this important first step, it will help set them up and possibly extend the possible overall life expectancy of them
It's not always apparent but it will take up to ten charges combined with use in your chosen device before a full capacity charge can be achieved, this is just a normal part of the conditioning process, each time you have used your battery in a more portable device then you should put it back on charge as soon as you can, do not leave it sitting in a semi discharged state for any longer than necessary, discharging the batteries fully will only reduce their life expectancy, you cannot kick start this kind of battery in that way, it will do them no good and will cost you money in the long run, if there are extended periods where you are not using the batteries you should remember to recharge every four weeks and never put them away discharged, even partially, do not leave on the charger for more than 24-hours at a time
The battery type is AGM which is short for absorbed glass mat construction, they are also valve regulated, they means they can be used around the home or in portable devices without the fear of any leakage, with deep cycle properties that this type of installation would require, they will require no maintenance throughout their entire life span and are not hazardous
So many codes on batteries are almost the same, you should carefully check them before ordering to ensure you are getting the right pack, if in doubt then look at your old one, take a note of the dimensions and anything that is written on the side, this will always be the best information to have, we have also included on the page the dimensions so you can confirm before ordering, the batteries themselves are 6-volt 1.2ah and have a very high lead content so they are recyclable, more detailed information about recycling lead batteries can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = VRLA, AGM
There are 1 ready to install batteries for the CAS Medical 901-BP Monitor the dimensions of the individual battery pack are as follows
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
