Criticare Systems 503-PRINTER sealed battery pack 6-volt AGM 1.2ah
Replacement Criticare Systems 503-PRINTER battery pack, rechargeable 6v 1.2ah sealed lead acid, safe non-spillable valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Here you will find we have offered on the page the relevant information to help you consider the decision of purchasing a new compatible replacement battery for your Criticare Systems 503-PRINTER, which are 6-volt and 1.2ah and capable of deep cycling, rechargeable and recyclable, the main component by far in the cells is lead this means they are a environmentally friendly as can very easily be made into something else, maybe another battery at the end of their life and the time comes for recycling, more information on this can be found on our recycling page
- Criticare Systems 503 PRINTER battery replacement
The batteries that you obtain from us will be almost fully charged, but you should still charge them fully before first use, however if it's a battery backup for something that's always connected to the mains like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, the time of the first charge will be dependent on the charger, just leave it on until its finished, it will probably not take very long, do not just install and use without this initial charge, unless as stated above, doing so can shorten expected life span, it's well worth doing
While is not something that most will even notice but it will take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, letting the batteries sit in a discharged state, even partially is not a good idea, so if being used in a portable device as soon as you have used them put them back on charge, never try to discharge the batteries all the way down, doing so with this type of battery will only reduce the life span and cost you money in the long run, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours
The battery type that we are offering her is VRLA and AGM, they need no maintenance, no topping up of fluids, they are sealed lead acid and valve regulated with AGM technology, they are not-hazardous and safe to use around the home or in portable devices well as travelling
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, these 6-volt 1.2-amp hour batteries are recyclable, the main component is lead which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 6-volts
Capacity = 1.2Ah @20Hr
Chemistry = AGM, VRLA, Pb
In this set there is 1 recyclable lead batteries for the Criticare Systems 503-PRINTER the overall size of the batteries are
Length = 97mm or 3.81-inches
Width = 24mm 0.94-inches
Height = 51.5mm or 2.02-inches
Battery layout - from chart below = 1
