MLA8491I 6-volt 3.2ah battery replacement rechargeable AGM VRLA
Replacement MLA8491I battery pack, valve regulated sealed lead acid compact and rechargeable 6-volt 3.2ah absorbed glass mat batteries, will not spill can be used in portable devices, offered at low prices direct from warehouse
Below printed on this page you will find we have listed detailed information which should be sufficient to help you consider the decision to buy new compatible replacement battery for your MLA8491I, which can be seen in medical devices portable and fixed as well as alarm systems are 6-volt and 3.2ah and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below
- MLA8491I battery replacement
After you have made and unpacked your new battery from us you will note that they will have a good charge in them, regardless of this you should still complete a full maintenance charge before first use, the only time you do not need to do this is if it's going into something with its own always connected power supply and charging circuit, for example a alarm system, as this will do the job of charging for you, it shouldn't take long as its almost fully charged already, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, do not miss out this very important first step, it will help set them up properly and possibly extend the possible overall life expectancy of them
It's not something that most will even notice but if being used in a portable device it may take a few charges and use in the equipment before a full capacity charge can be reached, it's all part of the normal conditioning process, each time you have used your battery in a more portable device then you should put it back on charge as soon as you can, it is not wise to leave it sitting in a semi discharged state for any longer than necessary, do not go out of your way to try discharge the batteries fully, this will not extend the life of them, quite the contrary, it will reduce life span quite drastically so cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These batteries will require no general maintenance, no topping up with fluid as it has none, the acid is suspended within a glass matting between the plates so will not spill, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices
We have provided the information here purely as a guide, it would be wise to check the code carefully as so many of them are pretty similar so it's easy to make a mistake, you will also find we have listed the relevant dimensions so you can make sure you are ordering the correct one, looking at your old power pack and taking note of the dimensions and anything that may be printed on the side is probably the best thing to do, the batteries themselves are 6-volt 3.2ah and have a very high lead or Pb content so they are easy to recyclable, more detailed information about recycling lead batteries can be found on a link at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM
In this pack there is 1 batteries to replace the MLA8491I we have mentioned the size below of each battery for your convenience
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
