Potter Electric Sign PFC100R replacement 6-volt battery sealed lead AGM
Replacement Potter Electric Sign PFC100R non-spillable small and compact sealed lead acid valve regulated 6-volt 3.2ah batteries, often used as backup or in portable devices AGM and VRLA, offered direct from warehouse at low cost
We have tried to list here, and hopefully succeeded on this page all the relevant information to help you make the decision of purchasing a new replacement compatible battery for your Potter Electric Sign PFC100R, which can be seen in medical devices portable and fixed as well as alarm systems are 6-volt and 3.2ah and capable of deep cycling, which are rechargeable, they are safe to handle and can be use indoors and in mobile applications, not-hazardous and will not spill, more information on their chemistry make up will be found below
- Potter Electric Sign PFC100R battery replacement
Upon receipt of your order from us the batteries will be almost fully charged but even so you will still need to complete a charge before first use, however if it's a battery backup for something that's always connected to the mains with its own built in charging circuit like a monitor or maybe a alarm system then you do not need to charge it first as the system will do that for you, the charge time will depend on your charger but as its almost fully charged it will not be long, just leave it on until it indicates its finished, do not just fit them without this initial charge, it will not take long anyway, it will not take long as it is almost fully charged anyway and it may help to extend the battery life overall
It's not always apparent but if you are using the battery in device that requires user action for the charging of it that it may take up to ten charges combined with use in your equipment before a full capacity charge can be achieved, this is just a normal part of the conditioning process, if being used in a portable device then you should make sure that after every use that you put the batteries back on charge, letting them sit in a partially discharged state is not wise, you cannot rejuvenate this kind of battery by deliberately running them down, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, If there are extended periods where the batteries are not being used then ensure they are fully charged beforehand then recharged every four weeks but you should not leave on the charger for more than 24-hours
These batteries will require no general maintenance, no topping up with fluid as it has none, the acid is suspended within a glass matting between the plates so will not spill, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices
We offer the information on this page purely as a guide only, if you carefully check the code then you should be ok, many are very similar so it's worth being vigilant, if in doubt look at your old battery, take note of the dimensions and anything written on the side of them, we have included the size below so you can double check, this 6-volt 3.2ah product is recyclable it is constructed mainly of lead or Pb which is easily transformed into another useful item, please ensure they are disposed of properly at a recycling centre once they have completely fulfilled their purpose for you, more information about recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = valve regulated lead acid, VRLA, AGM
In this pack there is 1 rechargeable lead acid batteries for the Potter Electric Sign PFC100R the overall size of the batteries are
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
