Eaton Powerware PW 9125 1000 UPS battery pack replacement VRLA
Replacement Eaton Powerware PW 9125 1000 rechargeable battery pack, valve regulated sealed lead UPS system batteries with VRLA and AGM technology at low competitive price direct from warehouse
The following information are details to be used for replacement batteries for the Eaton Powerware PW 9125 1000, it is powered by way of internal energy storage source these batteries are used to filter the mains supply and output a clean version without any spikes the cells are 12v cells, and comes with 2 x 12-volt batteries and that is what this offer is for these are rechargeable, non-spillable safe AGM, VRLA and capable of deep cycling which is vital in this sort of installation where they are constantly being used 24-hours a day
- Eaton Powerware PW 9125 1000 battery replacement
We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, with this in mind it will mean that there is a period of time that the system is unable to offer full runtime protection while it is doing this, if you can its best to do this initial charge without any load, we know this may not be convenient in a lot of installations but that is best advise
In this kind of device you would expect the batteries to last somewhere between two to five years, this can vary greatly on conditions, good ventilation, if it's in a office do not use it as a book shelf, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
The cells are absorbed glass mat or AGM, they are also valve regulated sealed lead acid or VRLA, this is the recommended type of battery for this installation, they will not leak if mounted on the side so safe to be used in tower or rack mountable configuration with fear of spillage in mission critical applications as well as the home office
Check the code on your system carefully so you order the right battery set, the batteries are made mainly from lead and recyclable, more information on recycling can be found at the foot of this page.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
We are offering a total of 2 batteries for use in the Eaton Powerware PW 9125 1000 we have mentioned the size below of each battery for your convenience
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
We are also able to offer this size battery as a 9-amp hour version, its exactly the same physical size and will slip straight in to the same cavity except it will offer a longer runtime and will probably last longer overall saving you money in the long run, link to this alternative is a bit further down the page
