Eaton Powerware PS10/0.6 replacement UPS battery set AGM
Replacement Eaton Powerware PS10/0.6 sealed lead battery pack, rechargeable UPS system valve regulated batteries, VRLA and AGM, they will not spill, safe to be mounted on the side at low competitive cost
Please find the information on this page to assist you in the renewal of batteries for your Eaton Powerware PS10/0.6, the onboard energy storage facility also filters the mains input supply before releasing on to your valuable equipment behind it and is powered by way of 12v cells, and comes with 2 x 12-volt batteries and that is what this offer is for which of course are rechargeable they are safe non-spillable AGM and VRLA type batteries, more information about the chemical make-up of them will be found below
- Eaton Powerware PS10/0.6 battery replacement
The batteries will come out to you almost fully charged, but the system will still want to finish off the full charge, with this in mind it will mean that there is a period of time that the system is unable to offer full runtime protection while it is doing this, we know it will not always be convenient as everything is a rush now days but if you can its best to run the system without any load to start
You would expect these kind of batteries to last between two to five years in this kind of device, this will however will vary greatly depending on the conditions or storage and overall use, good ventilation, if it's in a office do not use it as a book shelf, also do not overload, if you can keep the load below 40%, while the system will be more than capable of going higher than that it pays the price of working the battery cell harder which means a shorter life span
Batteries will require no maintenance, they are AGM and VRLA, they are also not-hazardous, they can be used in rack mountable or tower systems as they will not leak if mounted on the side
Ensure that you order the right battery by checking the code on your UPS and comparing it to the information here, many are very similar, these hot swap capable batteries are recyclable, more information on this can be found at the bottom on this page on our recycling link.
Voltage = 12-volts
Capacity = 7Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
In this pack there are a total of 2 quality batteries for the Eaton Powerware PS10/0.6 the dimensions of the individual battery pack are as follows
Length = 151mm
Width = 65mm
Height = 94mm
Battery layout - from chart below = 5
As an easy upgrade path we are able to offer this battery size as a 9ah version, it will slip straight into the same cavity but offer you a longer runtime, the link to this will be a little bit further below
