Eaton Powerware PS10/1.4 replacement UPS battery set AGM
Replacement Eaton Powerware PS10/1.4 UPS battery pack, valve regulated sealed lead acid rechargeable absorbed glass mat batteries that will not spill offered at low prices direct from warehouse
Please find the following details are for a set of batteries for the Eaton Powerware PS10/1.4, the system uses batteries to filter the input electricity and output a clean supply to protect your equipment behind it they are 12v cells, and comes with 2 x 12-volt batteries and that is what this offer is for these are rechargeable, non-spillable safe AGM, VRLA and capable of deep cycling which is vital in this sort of installation where they are constantly being used 24-hours a day
- Eaton Powerware PS10/1.4 battery replacement
We will send you batteries that are almost fully charged, your UPS will finish off the charge which helps it reset to the battery cell itself, with this in mind it will mean that there is a period of time that the system is unable to offer full runtime protection while it is doing this, we know it will not always be convenient as everything is a rush now days but if you can its best to run the system without any load to start
Batteries in this kind of installation will have a life span of between 2 to five years, this will be very dependent on the use and the way the system is stored, good ventilation, if it's in a office do not use it as a book shelf, keeping the load low will extend the life span, in a ideal world below 40%, they are so often run to the edge of their capabilities, while they may be able to do it its reducing the life span
These valve regulated sealed lead acid batteries will not leak so they can be mounted in tower or rack systems as they can be fitted on their side, they are not-hazardous so safe for busy data centres as well of course as the home office
This product is recyclable, please ensure they are disposed of at a recycling centre when they have fulfilled their purpose for you, check the product code carefully as many UPS systems have similar ones
Voltage = 12-volts
Capacity = 18Ah @20Hr
Chemistry = AGM, VRLA
Hot swap capable
There is a total of 2 rechargeable and recyclable batteries for the Eaton Powerware PS10/1.4 the physical size of the individual batteries are as follows
Length = 181mm
Width = 76mm
Height = 167mm
Battery layout - from chart below = 0
Hot swap capable, no maintenance required
