Vision CP632 6-volt 3.2ah battery replacement rechargeable AGM
Replacement Vision CP632 non spill compact 6-volt 3.2-amp hour battery pack, safe can be used in portable devices or energy backup, valve regulated sealed lead VRLA AGM rechargeable batteries at low cost
Below you will find we have hopefully listed all of the relevant information you will need to help you consider the decision on the purchase of a new compatible replacement battery for your Vision CP632, which can be seen in medical devices portable and fixed as well as alarm systems are 6-volt and 3.2ah and capable of deep cycling, which are rechargeable, they are safe to handle and can be use indoors and in mobile applications, not-hazardous and will not spill, more information on their chemistry make up will be found below
- Vision CP632 battery replacement
The batteries ordered will be delivered with a very good charge in them almost full, but even so you should still charge before using for the first time, the only time you do not need to do this is if it's going into something with its own always connected power supply and charging circuit, for example a alarm system, as this will do the job of charging for you, it shouldn't take long as its almost fully charged already, just until the charger lights indicates its ready, if really in doubt overnight will be more than enough but it's doubtful you would need to leave it on the charger that long, you might just want to fit them and use, but that would be unwise, unless being fitted in a device as stated above, missing out on charging them first may well shorten overall life expectancy
If being used in a portable device it may well take a number of charges and alternating use in your equipment for the battery to condition and be able to take a full capacity charge, this is quite normal, when you have used your portable device then ensure you put the batteries back on charge, you do not want to allow them to sit in a partially discharged state, you cannot rejuvenate this kind of battery by deliberately running them down, going out of your way to fully discharge the batteries will reduce their life span, so do not do it, if for any unforeseen reason they is an extended period where you are not using the batteries make sure they are fully charged first, then recharge every four weeks but do not leave on the charger for more than 24-hours
These batteries will require no general maintenance, no topping up with fluid as it has none, the acid is suspended within a glass matting between the plates so will not spill, they are AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices
Check the information carefully to ensure you are ordering the correct battery as many of them have very similar codes, if in doubt the dimensions of the batteries are probably your best guide and take note of anything that may be written on the side of them, the size of is also specified below so you can confirm, these 6v 3.2ah batteries are mainly constructed using lead which can easily be recycled, more information on recycling can be found at the foot of this page
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = VRLA, AGM
There are 1 ready to install batteries for the Vision CP632 here is the dimensions of a single battery
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
