IE1250 IE1260 Industrial Energy 12v 4.5ah battery replacement sealed
Replacement IE1250 IE1260 Industrial Energy battery pack, valve regulated sealed lead acid rechargeable 12-volt 4.5ah absorbed glass mat batteries, safe non-spillable AGM offered at low prices direct from our warehouse
Please find below detailed relevant information to help you consider the decision of the purchase of a new compatible replacement battery for your IE1250 IE1260 Industrial Energy, it is 12-volt with 4.5 amps of energy storage seen in a variety of applications from medical portable devices to backup household alarms and UPS systems as well as capable of deep cycling, being constructed as AGM and VRLA they are rechargeable, they are safe to be handled and to be used indoors or in portable devices, also recyclable the main component of the cells is lead so they are very easily recycled and environmentally friendly, more information can be found on our recycle page
- IE1250 IE1260 Industrial Energy battery replacement
When your order is delivered to you your new batteries will be almost fully charged, but regardless of this you should still complete a charge them before first use, if the battery is being fitted in something like an UPS system then you can miss this step as the on board circuit will do a better job of charging it than you, you do not need to leave it on for hours on end, it will probably not take very long at all depending on the charger, just until the charger has indicated that it has finished, you may well just want to fit them and use the equipment, but do not miss this first step if needed, it's worth waiting until the first charge has completed and it may well contribute to over life span
it may well take up to ten charges and alternating use in your equipment for the battery to fully condition and be able to take a full capacity charge, this is all quite normal, after use recharge as soon as you can, you do not want to allow them to sit in a partially discharged state, never try to discharge the batteries all the way down, doing so with this type of battery will only reduce the life span and cost you money in the long run, these batteries need to be kept charged, so if there is any reason where they are not be used then ensure they are charged beforehand and then every 4-weeks, but do not leave on a charger for more than 24-hours
These batteries will require no general maintenance, no topping up with fluid as it has none, they are 12-volt AGM and VRLA, of course with deep cycle properties that would be required in this type of application, they are also not-hazardous so safe to use in the home or in portable devices
Please note you should use all the information on this page only a guide, while we have tried here to assist you in getting the correct battery, it should be noted that there are many very similar codes, if you are not sure you should always double check what you have before ordering, this may also give you the opportunity to see how easy it is going to be to change them, take note of the dimensions and anything written on the side of them, all the physical sizes are listed on this page, these 12v 4.5ah batteries are constructed mainly of lead which is easy to recycle and transform into another product so therefore environmentally friendly, more information regarding recycling will be found at a link at the foot of this page
Voltage = 12-volts
Capacity = 4.5Ah @20Hr
Chemistry = Pb, sealed lead acid, VRLA, AGM
This set contains 1 rechargeable batteries for the IE1250 IE1260 Industrial Energy the overall size of the batteries are
Length = 90mm or 3.54-inches
Width = 70mm 2.75-inches
Height = 101mm or 3.97-inches
Battery layout - from chart below = 1
If you would like to achieve more mileage from your battery and equipment then we can offer you a easy upgrade, a 5ah battery set will directly replace these and with the same physical size will slip straight in, the link to this extended option can be found just a little bit further down the page
