PR1000ELCDRT1U RBP0027 battery UPS CyberPower replacement
Four Replacement batteries for RBP0027 module in CyberPower PR1000ELCDRT1U UPS, rechargeable sealed batteries are non-hazardous, non-spillable at low prices.
- Cyberpower RBP0027 battery
- Cyberpower PR1000ELCDRT1U battery
The CyberPower PR1000ELCDRT1U UPS system offers power protection for office system devices, including PCs, workstations and networking equipment. It features smooth Pure Sine Wave and has increased versatility for installation and operation in practically any environment thanks to the rackmount and tower convertible design. The UPS supports battery hot-swapping, which enables users to do standard battery maintenance without experiencing a lot of disruption.
The replacement battery pack Series, created for UPS systems, gives a new life so they may sustain the performance of the system. Thanks to its ready-to-use battery packs, users can effortlessly change the batteries when needed.
Charging and maintenance:
The battery must be recharged for at least eight hours in order to guarantee that it receives its full charge capacity. Loss of charge is a possibility during storage and transportation. To recharge the battery, simply leave the device plugged into an AC outlet. The device can be charged in both the on and off settings. If storing your UPS for a period of time, ensure to keep fully charged before storing, and recharge every three months.
Replacing batteries:
To ensure safety, turn off and unplug all connected devices before you start. The UPS can then be disconnected from the AC power source and switched off. Next, remove the front panel of the UPS by fully unscrewing the top and unscrewing two screws from the battery compartment cover. The old battery cables should be unplugged after removing the batteries from the container. Replace the batteries in the compartment after connecting the wire bundle (one red and one black wire) to the connector from the battery pack. Replace the front panel on the UPS and secure the battery compartment cover with the retaining screws. Charge the UPS for eight to sixteen hours before using.
For more information please visit the downloads tab on this page and see the user manual and battery replacement instructions attached.
Battery disposal:
The batteries are made of sealed lead-acid and can be disposed of at your local recycling centre. For more information on this please visit the link at the foot of this page.
Dimensions (per individual battery):
Four batteries are in this set
Length: 151mm / 5.94-inches
Width: 34mm / 1.33-inches
Height: 94mm / 3.7-inches
Specifications:
Voltage: 6v
Capacity: 7Ah @20Hr
Chemistry: Sealed lead-acid, VRLA, AGM, Pb
