Cutter Labs FLO Volumetric 6-volt battery replacement sealed AGM VRLA
Replacement Cutter Labs FLO Volumetric battery pack, rechargeable compact 6v 3.2ah sealed lead acid, safe non-spillable so can be used in portable equipment, valve regulated VRLA batteries with advanced AGM technology at low competitive cost
Below you will hopefully find we have entered all of the relevant details for you to decide on the purchase of a new compatible battery you will require for the Cutter Labs FLO Volumetric, which has a energy storage capacity of 3.2-amp hours, this size battery is often used in medical devices, portable and fixed and also commercial and home alarm systems as well as other uses, the cells are 6-volt and capable of deep cycling, they are as would be needed rechargeable and not-hazardous and will not spill so therefore safe to be handled and to use indoors or in portable equipment, AGM and VRLA cells, more information about these chemistries will be found below
- Cutter Labs FLO Volumetric battery replacement
After placing you and receipt of your order you will note that the batteries will be almost fully charged when received, but you should still maintain a full charge before first use, the only time you do not need to do this is if it's going into something with its own always connected power supply and charging circuit, for example a alarm system, as this will do the job of charging for you, you only need to complete the charge until the charger indicates that its ready, it probably will not take long but it is very important so not a step you should overlook, try to make sure you do not miss the initial charge (unless of course being fitted in a device with own circuit as stated above), doing so may well reduce overall life expectancy
While is not something that most will even notice but if being used in a portable piece of equipment it could take a number of charges and corresponding use in the device before a full capacity charge is reached, this is a normal part of the conditioning process, once you have used your portable equipment then make sure you put the batteries back on charge afterwards, do not let them sit in a partially discharged state for any longer than absolutely necessary, you should never deliberately go out of your way to try fully discharge the batteries, we are often asked will this extend the life but no this will only reduce its life span and cost you money in the long run, if it turns out there are periods where the equipment is not being used on a regular basis then ensure the batteries are fully charged before any period of downtime and then topped up every four weeks but do not leave on the charger for more than 24-hours
This type of battery is valve regulated lead acid, VRLA for short, they still have acid but its trapped between a glass matting, this is why they are also called AGM or absorbed glass mat, you will never to need to top them up with fluid, if fact you cannot as they are sealed, they are not-hazardous and can safely be used indoors or in portable devices with no fear of leakage
The information we have provided on this page should only be used as a guide, you should carefully check before ordering as many are very similar, if still in doubt you can look at your old battery, take a note of the dimensions and anything that may be written on the side of them, this will always be the best way, we have also included the physical dimensions on this page so you can confirm, these 6-volt 3.2-amp hour batteries are recyclable, the main constructive component is lead or Pb which can easily be recycled, more information on this can be found at the bottom on this page on our recycling link
Voltage = 6-volts
Capacity = 3.2Ah @20Hr
Chemistry = VRLA, AGM, sealed lead, Pb
There is 1 quality lead acid batteries for the Cutter Labs FLO Volumetric the dimensions of the individual battery pack are as follows
Length = 134mm or 5.27-inches
Width = 34mm 1.33-inches
Height = 60mm or 2.36-inches
Battery layout - from chart below = 1
